Sennheiser HMEC 26-2 Adjusting the volume, Switching between mono and stereo mode

Page 13
Adjusting the volume

Using the headset

Adjusting the volume

The two slide volume controls 1 allow you to adjust the volume for the left and right channel separately.

CAUTION

Hearing damage due to high volumes!

This headset is capable of producing high sound pressure levels. Higher volumes or longer durations can damage your hearing!

￿Set the volume to a medium level. Make sure that you can hear critical sounds such as warning alarms.

Switching between mono and stereo mode

The mono/stereo switch 4 allows you to switch between mono ( ) and stereo ( ) mode, depending on the audio system.

Changing the left and right stereo channel

The position “R” or “L” of the BOOM switch 5 corresponds to the position of the microphone on the left or right side of the mouth. When the microphone boom is rotated to permit left or right side microphone orientation, the BOOM switch allows you to correctly assign the audio channels (L/R) to the appropriate headphone sides. This enables the correct orientation of the volume controls and any stereo audio signals. To move the BOOM switch, use a pointed tool.

12 HMEC 26-2

Image 13
Contents HMEC Preventing health problems and accidents Important safety informationOnly clean the product with a soft, dry cloth Preventing damage to the product and dysfunctionsIntended use of the product includes Intended useFeatures The HMEC 26-2 headsetPackage contents Putting on the headset OperationFlipping away one earcup OperationTurning the microphone boom Positioning the microphoneAdjusting the microphone sensitivity Adjusting the volume directly on the audio systemHearing damage due to high volumes The control units of the HMEC 5 BOOM switch L /RControl unit 1 2 3 4 5 6Cable -DP-2 Cable -CP Cable -CP-2 Cable -KP Cable -KP-2 Cable -NP Cable -RP-210 HMEC Switching NoiseGard on/off Using the headsetSwitching between mono and stereo mode Adjusting the volumeChanging the left and right stereo channel Activating the “auto shut-off” function Powering NoiseGard via two rechargeable batteriesMeaning Set the switch to the position ASO Switching the TalkThrough function on/off HMEC 26-2-T onlyDanger of accident due to reduced attention Connecting a mobile telephoneConnecting an additional audio player Attaching the belt clip 18 HMEC Attaching the cable clipCleaning and maintaining the headset Care and maintenanceReplacing the ear pads Put the new headband paddings around the headbands Replacing the headband paddingsAttach the new headband paddings by joining the fastenings strips 20 HMECAccessories Accessories and spare partsCable clip Spare partsAudio cable, length 0.6 m 2 x 3.5 mm stereo jack plug Audio cable, length 0.6 m, 2 x 2.5 mm jack plugProduct and cable variants Cat. No ModelPart Number 24 HMEC1 2 3 4 5 6 7 8 9 A B C D E F G These headsets can be combined with all cables see pageSpecifications SpecificationsHeadphones 26 HMECGeneral data Microphone incl. preamplifierNoiseGard professional Cable -V-KX-2 Connector assignmentCable -CP, -CP-2, -B-CP-2 Cable -NPCable -DP-2 Cable -RP-2Cable -KP, -KP-2, -B-K-2, -B-KP-2, -BV-K-2 Cable -B-K-2Manufacturer Declarations WarrantyIn compliance with the following requirements In compliance withSennheiser electronic GmbH & Co. KG