Sennheiser HMEC 26-2 instruction manual Preventing damage to the product and dysfunctions

Page 3

Important safety information

NoiseGardTM switched on, you can hear and recognize these sounds. Set the volume to safe levels that do not interfere with your ability to hear informational sounds and warning alarms.

￿The product is capable of producing sound pressure exceeding 85 dB(A). In many countries 85 dB(A) is the maximum legally permissible level for continuous noise exposure during the working day. Do not listen at high volume levels for long periods of time to prevent hearing damage.

Preventing damage to the product and dysfunctions

￿Always keep the product dry and do not expose it to extreme temperatures (hairdryer, heater, extended exposure to sunlight, etc.) to avoid corrosion or deformation.

￿Only clean the product with a soft, dry cloth.

￿Never repair or attempt to repair a defective product yourself. Contact your Sennheiser partner or the Sennheiser Service Department.

￿Only replace parts of the product whose replacement is described in this manual. All other parts of the product must be replaced by your Sennheiser partner.

2 HMEC 26-2

Image 3
Contents HMEC Preventing health problems and accidents Important safety informationOnly clean the product with a soft, dry cloth Preventing damage to the product and dysfunctionsIntended use of the product includes Intended useFeatures The HMEC 26-2 headsetPackage contents Operation OperationPutting on the headset Flipping away one earcupTurning the microphone boom Positioning the microphoneAdjusting the volume directly on the audio system Adjusting the microphone sensitivityHearing damage due to high volumes 1 2 3 4 5 6 5 BOOM switch L /RThe control units of the HMEC Control unitCable -CP Cable -CP-2 Cable -KP Cable -KP-2 Cable -NP Cable -RP-2 Cable -DP-210 HMEC Switching NoiseGard on/off Using the headsetAdjusting the volume Switching between mono and stereo modeChanging the left and right stereo channel Powering NoiseGard via two rechargeable batteries Activating the “auto shut-off” functionMeaning Set the switch to the position ASO Switching the TalkThrough function on/off HMEC 26-2-T onlyDanger of accident due to reduced attention Connecting a mobile telephoneConnecting an additional audio player Attaching the belt clip 18 HMEC Attaching the cable clipCare and maintenance Cleaning and maintaining the headsetReplacing the ear pads 20 HMEC Replacing the headband paddingsPut the new headband paddings around the headbands Attach the new headband paddings by joining the fastenings stripsAccessories Accessories and spare partsAudio cable, length 0.6 m, 2 x 2.5 mm jack plug Spare partsCable clip Audio cable, length 0.6 m 2 x 3.5 mm stereo jack plugProduct and cable variants 24 HMEC ModelCat. No Part Number1 2 3 4 5 6 7 8 9 A B C D E F G These headsets can be combined with all cables see page26 HMEC SpecificationsSpecifications HeadphonesMicrophone incl. preamplifier General dataNoiseGard professional Cable -NP Connector assignmentCable -V-KX-2 Cable -CP, -CP-2, -B-CP-2Cable -B-K-2 Cable -RP-2Cable -DP-2 Cable -KP, -KP-2, -B-K-2, -B-KP-2, -BV-K-2In compliance with WarrantyManufacturer Declarations In compliance with the following requirementsSennheiser electronic GmbH & Co. KG