Sennheiser HMEC 26-2 instruction manual Adjusting the volume directly on the audio system

Page 9

Adjusting the volume directly on the audio system

Operation

Adjusting the volume directly on the audio system

Connect the headset to the corresponding sockets of your audio system. Adjust the volume directly on the audio system.

CAUTION

Hearing damage due to high volumes!

This headset is capable of producing high sound pressure levels. Higher volumes or longer durations can damage your hearing!

Set the volume to a medium level. Make sure that you can hear critical sounds such as warning alarms.

Adjusting the microphone sensitivity

Turn a small screwdriver in the direction of the arrow to change the microphone sensitivity.

–+

8 HMEC 26-2

Image 9

Contents HMEC Preventing health problems and accidents Important safety informationOnly clean the product with a soft, dry cloth Preventing damage to the product and dysfunctionsIntended use of the product includes Intended useFeatures The HMEC 26-2 headsetPackage contents Putting on the headset OperationFlipping away one earcup OperationTurning the microphone boom Positioning the microphoneAdjusting the volume directly on the audio system Adjusting the microphone sensitivityHearing damage due to high volumes The control units of the HMEC 5 BOOM switch L /RControl unit 1 2 3 4 5 6Cable -CP Cable -CP-2 Cable -KP Cable -KP-2 Cable -NP Cable -RP-2 Cable -DP-210 HMEC Switching NoiseGard on/off Using the headsetAdjusting the volume Switching between mono and stereo modeChanging the left and right stereo channel Powering NoiseGard via two rechargeable batteries Activating the “auto shut-off” functionMeaning Set the switch to the position ASO Switching the TalkThrough function on/off HMEC 26-2-T onlyDanger of accident due to reduced attention Connecting a mobile telephoneConnecting an additional audio player Attaching the belt clip 18 HMEC Attaching the cable clipCare and maintenance Cleaning and maintaining the headsetReplacing the ear pads Put the new headband paddings around the headbands Replacing the headband paddingsAttach the new headband paddings by joining the fastenings strips 20 HMECAccessories Accessories and spare partsCable clip Spare partsAudio cable, length 0.6 m 2 x 3.5 mm stereo jack plug Audio cable, length 0.6 m, 2 x 2.5 mm jack plugProduct and cable variants Cat. No ModelPart Number 24 HMEC1 2 3 4 5 6 7 8 9 A B C D E F G These headsets can be combined with all cables see pageSpecifications SpecificationsHeadphones 26 HMECMicrophone incl. preamplifier General dataNoiseGard professional Cable -V-KX-2 Connector assignmentCable -CP, -CP-2, -B-CP-2 Cable -NPCable -DP-2 Cable -RP-2Cable -KP, -KP-2, -B-K-2, -B-KP-2, -BV-K-2 Cable -B-K-2Manufacturer Declarations WarrantyIn compliance with the following requirements In compliance withSennheiser electronic GmbH & Co. KG