Sennheiser HMEC 26-2 instruction manual Product and cable variants

Page 24
Product and cable variants

Product and cable variants

Product and cable variants

The following cables, connectors, control units and features are available for the HMEC 26-2 variants (see table on the following pages):

1Headphhones with +6 dB characteristic SPL

2Microphone with 60 mV output voltage

3Single-sided round cable, 1.7 m

4XLR-5 connector

5¼“ (6.3 mm) jack plug (headphones)

6PJ-068 equivalent (microphone)

78-pin Neutricon connector

86-pin Redel connector

9XLR-6 connector

<XLR-3 connector A Aircraft powered B Battery powered

C Control unit I (see page 9) D Control unit II (see page 10)

EAudio cable (1 cable with 2.5 mm jack plugs and 1 cable with 3.5 mm jack plugs)

FBelt clip

GCarry bag

HMEC 26-2 23

Image 24
Contents HMEC Important safety information Preventing health problems and accidentsPreventing damage to the product and dysfunctions Only clean the product with a soft, dry clothIntended use Intended use of the product includesThe HMEC 26-2 headset FeaturesPackage contents Operation Putting on the headsetFlipping away one earcup OperationPositioning the microphone Turning the microphone boomAdjusting the volume directly on the audio system Adjusting the microphone sensitivityHearing damage due to high volumes 5 BOOM switch L /R The control units of the HMECControl unit 1 2 3 4 5 6Cable -CP Cable -CP-2 Cable -KP Cable -KP-2 Cable -NP Cable -RP-2 Cable -DP-210 HMEC Using the headset Switching NoiseGard on/offAdjusting the volume Switching between mono and stereo modeChanging the left and right stereo channel Powering NoiseGard via two rechargeable batteries Activating the “auto shut-off” functionMeaning Switching the TalkThrough function on/off HMEC 26-2-T only Set the switch to the position ASOConnecting a mobile telephone Danger of accident due to reduced attentionConnecting an additional audio player Attaching the belt clip Attaching the cable clip 18 HMECCare and maintenance Cleaning and maintaining the headsetReplacing the ear pads Replacing the headband paddings Put the new headband paddings around the headbandsAttach the new headband paddings by joining the fastenings strips 20 HMECAccessories and spare parts AccessoriesSpare parts Cable clipAudio cable, length 0.6 m 2 x 3.5 mm stereo jack plug Audio cable, length 0.6 m, 2 x 2.5 mm jack plugProduct and cable variants Model Cat. NoPart Number 24 HMECThese headsets can be combined with all cables see page 1 2 3 4 5 6 7 8 9 A B C D E F GSpecifications SpecificationsHeadphones 26 HMECMicrophone incl. preamplifier General dataNoiseGard professional Connector assignment Cable -V-KX-2Cable -CP, -CP-2, -B-CP-2 Cable -NPCable -RP-2 Cable -DP-2Cable -KP, -KP-2, -B-K-2, -B-KP-2, -BV-K-2 Cable -B-K-2Warranty Manufacturer DeclarationsIn compliance with the following requirements In compliance withSennheiser electronic GmbH & Co. KG