Sennheiser HMEC 26-2 Connecting a mobile telephone, Danger of accident due to reduced attention

Page 16

Using the headset

TalkThrough can only be used when the NoiseGard™ active noise compensation is switched on.

Connecting a mobile telephone

The 2.5 mm jack socket 8 allows you to connect a mobile telephone. For this purpose, the NoiseGard™ active noise compensation must be switched on and the microphone connector must be connected to the aircraft radio/audio. A suitable adapter for your mobile telephone with 2.5 mm jack socket is available from your specialist retailer.

CAUTION

Danger of accident due to reduced attention!

Making telephone calls or operating the mobile telephone limits your attention and may cause accidents.

During flight operation, do not use the headset for telephone calls!

HMEC 26-2 15

Image 16

Contents HMEC Important safety information Preventing health problems and accidentsPreventing damage to the product and dysfunctions Only clean the product with a soft, dry clothIntended use Intended use of the product includesThe HMEC 26-2 headset FeaturesPackage contents Operation Putting on the headsetFlipping away one earcup OperationPositioning the microphone Turning the microphone boomAdjusting the microphone sensitivity Adjusting the volume directly on the audio systemHearing damage due to high volumes 5 BOOM switch L /R The control units of the HMECControl unit 1 2 3 4 5 6Cable -DP-2 Cable -CP Cable -CP-2 Cable -KP Cable -KP-2 Cable -NP Cable -RP-210 HMEC Using the headset Switching NoiseGard on/offSwitching between mono and stereo mode Adjusting the volumeChanging the left and right stereo channel Activating the “auto shut-off” function Powering NoiseGard via two rechargeable batteriesMeaning Switching the TalkThrough function on/off HMEC 26-2-T only Set the switch to the position ASOConnecting a mobile telephone Danger of accident due to reduced attentionConnecting an additional audio player Attaching the belt clip Attaching the cable clip 18 HMECCleaning and maintaining the headset Care and maintenanceReplacing the ear pads Replacing the headband paddings Put the new headband paddings around the headbandsAttach the new headband paddings by joining the fastenings strips 20 HMECAccessories and spare parts AccessoriesSpare parts Cable clipAudio cable, length 0.6 m 2 x 3.5 mm stereo jack plug Audio cable, length 0.6 m, 2 x 2.5 mm jack plugProduct and cable variants Model Cat. NoPart Number 24 HMECThese headsets can be combined with all cables see page 1 2 3 4 5 6 7 8 9 A B C D E F GSpecifications SpecificationsHeadphones 26 HMECGeneral data Microphone incl. preamplifierNoiseGard professional Connector assignment Cable -V-KX-2Cable -CP, -CP-2, -B-CP-2 Cable -NPCable -RP-2 Cable -DP-2Cable -KP, -KP-2, -B-K-2, -B-KP-2, -BV-K-2 Cable -B-K-2Warranty Manufacturer DeclarationsIn compliance with the following requirements In compliance withSennheiser electronic GmbH & Co. KG