Sennheiser instruction manual Switching the TalkThrough function on/off HMEC 26-2-T only

Page 15
￿Set the switch to the position ASO.

Using the headset

￿Set the switch to the position ASO.

Switching the TalkThrough function on/off (HMEC 26-2-T only)

The headset provides excellent attenuation of ambient noise. In order to allow you to communicate undisturbed with your surroundings while wearing the headset, the HMEC 26-2-T features a TalkThrough function. With TalkThrough switched on, a separate microphone 9picks up acoustic signals in the immediate vicinity. Unwanted background noise is filtered out, only allowing the voice of the other person to pass through the headset.

￿Press the button A to switch the TalkThrough function on. The LED < lights up. Press the button again to switch TalkThrough off.

14 HMEC 26-2

Image 15
Contents HMEC Preventing health problems and accidents Important safety informationOnly clean the product with a soft, dry cloth Preventing damage to the product and dysfunctionsIntended use of the product includes Intended useFeatures The HMEC 26-2 headsetPackage contents Operation OperationPutting on the headset Flipping away one earcupTurning the microphone boom Positioning the microphoneAdjusting the volume directly on the audio system Adjusting the microphone sensitivityHearing damage due to high volumes 1 2 3 4 5 6 5 BOOM switch L /RThe control units of the HMEC Control unitCable -CP Cable -CP-2 Cable -KP Cable -KP-2 Cable -NP Cable -RP-2 Cable -DP-210 HMEC Switching NoiseGard on/off Using the headsetAdjusting the volume Switching between mono and stereo modeChanging the left and right stereo channel Powering NoiseGard via two rechargeable batteries Activating the “auto shut-off” functionMeaning Set the switch to the position ASO Switching the TalkThrough function on/off HMEC 26-2-T onlyDanger of accident due to reduced attention Connecting a mobile telephoneConnecting an additional audio player Attaching the belt clip 18 HMEC Attaching the cable clipCare and maintenance Cleaning and maintaining the headsetReplacing the ear pads 20 HMEC Replacing the headband paddingsPut the new headband paddings around the headbands Attach the new headband paddings by joining the fastenings stripsAccessories Accessories and spare partsAudio cable, length 0.6 m, 2 x 2.5 mm jack plug Spare partsCable clip Audio cable, length 0.6 m 2 x 3.5 mm stereo jack plugProduct and cable variants 24 HMEC ModelCat. No Part Number1 2 3 4 5 6 7 8 9 A B C D E F G These headsets can be combined with all cables see page26 HMEC SpecificationsSpecifications HeadphonesMicrophone incl. preamplifier General dataNoiseGard professional Cable -NP Connector assignmentCable -V-KX-2 Cable -CP, -CP-2, -B-CP-2Cable -B-K-2 Cable -RP-2Cable -DP-2 Cable -KP, -KP-2, -B-K-2, -B-KP-2, -BV-K-2In compliance with WarrantyManufacturer Declarations In compliance with the following requirementsSennheiser electronic GmbH & Co. KG