Sennheiser HMEC 26-2 instruction manual Care and maintenance, Cleaning and maintaining the headset

Page 20

Care and maintenance

Cleaning and maintaining the headset

CAUTION

Liquids can damage the product!

Liquids entering the product can short-circuit the electronics or damage the mechanics. Solvents or cleansing agents can damage the surface of the product.

Keep all liquids far away from the product.

Before cleaning, pull out the plugs of the product from the connections in the aircraft.

Only use a soft, dry cloth to clean the product.

Replacing the ear pads

For reasons of hygiene, you should replace the ear pads annually.

Grasp the edge of the ear pad and pull sharply.

Attach the new ear pad to the ear cup by pressing firmly around the ear pad until you hear all 12 latches lock into place.

HMEC 26-2 19

Image 20

Contents HMEC Important safety information Preventing health problems and accidentsPreventing damage to the product and dysfunctions Only clean the product with a soft, dry clothIntended use Intended use of the product includesThe HMEC 26-2 headset FeaturesPackage contents Operation Putting on the headsetFlipping away one earcup OperationPositioning the microphone Turning the microphone boomHearing damage due to high volumes Adjusting the volume directly on the audio systemAdjusting the microphone sensitivity 5 BOOM switch L /R The control units of the HMECControl unit 1 2 3 4 5 610 HMEC Cable -CP Cable -CP-2 Cable -KP Cable -KP-2 Cable -NP Cable -RP-2Cable -DP-2 Using the headset Switching NoiseGard on/offChanging the left and right stereo channel Adjusting the volumeSwitching between mono and stereo mode Meaning Powering NoiseGard via two rechargeable batteriesActivating the “auto shut-off” function Switching the TalkThrough function on/off HMEC 26-2-T only Set the switch to the position ASOConnecting a mobile telephone Danger of accident due to reduced attentionConnecting an additional audio player Attaching the belt clip Attaching the cable clip 18 HMECReplacing the ear pads Care and maintenanceCleaning and maintaining the headset Replacing the headband paddings Put the new headband paddings around the headbandsAttach the new headband paddings by joining the fastenings strips 20 HMECAccessories and spare parts AccessoriesSpare parts Cable clipAudio cable, length 0.6 m 2 x 3.5 mm stereo jack plug Audio cable, length 0.6 m, 2 x 2.5 mm jack plugProduct and cable variants Model Cat. NoPart Number 24 HMECThese headsets can be combined with all cables see page 1 2 3 4 5 6 7 8 9 A B C D E F GSpecifications SpecificationsHeadphones 26 HMECNoiseGard professional Microphone incl. preamplifierGeneral data Connector assignment Cable -V-KX-2Cable -CP, -CP-2, -B-CP-2 Cable -NPCable -RP-2 Cable -DP-2Cable -KP, -KP-2, -B-K-2, -B-KP-2, -BV-K-2 Cable -B-K-2Warranty Manufacturer DeclarationsIn compliance with the following requirements In compliance withSennheiser electronic GmbH & Co. KG