Sennheiser HMEC 26-2 instruction manual Positioning the microphone, Turning the microphone boom

Page 8

Operation

Positioning the microphone

Bend the flexible microphone boom so that the microphone is placed at the corner of the mouth. Maintain a distance of 2 cm between microphone and mouth. Always use the supplied wind and pop screen.

Turning the microphone boom

The microphone boom can be rotated. This allows the headset to be worn with the microphone boom positioned on either the left or right-hand side of the head.

HMEC 26-2 7

Image 8

Contents HMEC Important safety information Preventing health problems and accidentsPreventing damage to the product and dysfunctions Only clean the product with a soft, dry clothIntended use Intended use of the product includesThe HMEC 26-2 headset FeaturesPackage contents Operation Putting on the headsetFlipping away one earcup OperationPositioning the microphone Turning the microphone boomHearing damage due to high volumes Adjusting the volume directly on the audio systemAdjusting the microphone sensitivity 5 BOOM switch L /R The control units of the HMECControl unit 1 2 3 4 5 610 HMEC Cable -CP Cable -CP-2 Cable -KP Cable -KP-2 Cable -NP Cable -RP-2Cable -DP-2 Using the headset Switching NoiseGard on/offChanging the left and right stereo channel Adjusting the volumeSwitching between mono and stereo mode Meaning Powering NoiseGard via two rechargeable batteriesActivating the “auto shut-off” function Switching the TalkThrough function on/off HMEC 26-2-T only Set the switch to the position ASOConnecting a mobile telephone Danger of accident due to reduced attentionConnecting an additional audio player Attaching the belt clip Attaching the cable clip 18 HMECReplacing the ear pads Care and maintenanceCleaning and maintaining the headset Replacing the headband paddings Put the new headband paddings around the headbandsAttach the new headband paddings by joining the fastenings strips 20 HMECAccessories and spare parts AccessoriesSpare parts Cable clipAudio cable, length 0.6 m 2 x 3.5 mm stereo jack plug Audio cable, length 0.6 m, 2 x 2.5 mm jack plugProduct and cable variants Model Cat. NoPart Number 24 HMECThese headsets can be combined with all cables see page 1 2 3 4 5 6 7 8 9 A B C D E F GSpecifications SpecificationsHeadphones 26 HMECNoiseGard professional Microphone incl. preamplifierGeneral data Connector assignment Cable -V-KX-2Cable -CP, -CP-2, -B-CP-2 Cable -NPCable -RP-2 Cable -DP-2Cable -KP, -KP-2, -B-K-2, -B-KP-2, -BV-K-2 Cable -B-K-2Warranty Manufacturer DeclarationsIn compliance with the following requirements In compliance withSennheiser electronic GmbH & Co. KG