Cisco TelePresence System Codec C90 and Profile 65” Dual using C90
Contents | Introduction | Web interface | Advanced configuration | Password protection | Appendices |
Administrator guide
Contact us
Change the user passwords
All users can change their own codec password as described on the previous page.
If you have ADMIN rights, you can change all users’ passwords by performing the following steps:
1.Log in to the web interface with username and password.
2.Go to the Users page.
3.Select the appropriate user from the list.
4.Enter a new password and PIN code.
5.Click Save.
Set a root password
If you log in to the command line interface as root, you can access the codec’s file system.
The root user is disabled by default.
Perform the following steps to activate the root user and set a password:
1.Connect to the codec through the network or the serial data port, using a command line interface (SSH or Telnet).
2.Log in to the codec with the username (admin) and password. You need ADMIN rights.
3.Run the following API command:
systemtools rootsettings on <password>
NOTE: The root password is not the same as the administrator password.
D14635.05 Profile C90 and Codec C90 Administrator Guide TC4.1, February 2011. | 72 | www.cisco.com |
Copyright © |