Black Box FX150A manual FCC Statement

Page 2

FCC STATEMENT

FEDERAL COMMUNICATIONS COMMISSION

RADIO FREQUENCY INTERFERENCE STATEMENT

Class B Digital Device. This equipment has been tested and found to comply with the limits for a Class B computing device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to radio or telephone reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult an experienced radio/TV technician for help.

Caution:

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

To meet FCC requirements, shielded cables and power cords are required to connect this device to a personal computer or other Class B certified device.

3

Image 2
Contents Lineshare Pro AC FCC Statement Lineshare PRO NOM Statement Trademarks Contents Lineshare PRO Specifications Before You Begin About the Lineshare ProLineshare PRO Installation Ports on the Lineshare ProRear Panel of the Lineshare Pro Telephone Wall Jack Volt TelephoneOutlet Wall Jack Connecting Telephone Equipment to the Lineshare Pro Outlet Lineshare Pro Installed on an Extension Lineshare PRO Lineshare PRO Phone Company Junction Box Red Green Installing the Lineshare Pro on a KSU or PBX System Lineshare Pro Installed on a KSU Or PBX Phone System Special Operating Notes Lineshare Pro Call RoutingLineshare PRO Answering Calls with a TAD Answering Incoming CallsAnswering Calls from Port Placing an Outbound Call Retrieving TAD Messages from a Remote LocationEmergency Call Override Sending a Fax Or Modem Transmission Receiving a Computer Call to a PortLineshare PRO Using Single-Frequency Tone Detection Lineshare PRO Using the Lineshare Pro’s Custom Features and Functions Lineshare Pro Features Feature Lineshare Pro Functions OFFFactory Setting Changing ON/OFF features Extension DetectionHome Routing Secured OperationNo Answer Cascade Answer/Disconnect CascadePulse Transfer Open Line Notification OLNInbound Tone Transfer Ring ReductionChanging Function Options Outbound Tone TransferProtocol Tone Access Signal Detection Dual Tone DetectionProtocol Tone Access Signal Assignment Keypad # Protocol Tone Access Signal Cascade Port Order Phantom Ring Style Emergency Call OverrideDual Tone Assignments Rings Available to the Ports Extension Detection TimerTime at Home 9 Reset to Factory Settings Rings to Answer CallCopyright 1996. Black Box Corporation. All rights reserved