Black Box FX150A manual Home Routing, Secured Operation

Page 38

LINESHARE PRO

factory-preset OFF, 0 0 *. To turn the Extension Detection feature ON, enter the programming mode and press the following on your tone phone:

1 Turn ON

0 Extension Detection

*End programming sequence (3 beeps indicate correct entry)

(Optional entries for additional changes)

*Save changes and exit programming

[1]Home Routing

Home Routing operates only when the Lineshare Pro is configured in the secured mode.

This feature enables the Lineshare Pro to hold the phone line after a device disconnects from a call and then route it to another port, or “home.” Home is a temporary state where the caller must enter an access code, or a single-frequency protocol tone, to access another port.

When a call is rerouted home, the amount of time that the caller has to select another port is limited by the Time at Home function. If the caller does not enter a tone to access another port during this time, the Lineshare Pro disconnects the call.

The Home Routing feature is factory-preset OFF, 0 1 *.

Turn this feature ON if you want to allow access of multiple ports during a single call in the secured mode.

To turn Home Routing ON, enter the programming mode and press the following on your tone phone:

1 Turn ON

1 Home Routing

*End programming sequence (3 beeps indicate correct entry)

(Optional entries for additional changes)

*Save changes and exit programming

[2]Secured Operation

When the Lineshare Pro is in the secured mode, the following features are affected regardless of their programming defaults or current settings:

0 Extension Detection is OFF.

3 No Answer Cascade is OFF.

4 Answer/Disconnect Cascade is OFF.

5 Pulse Transfer is OFF.

6 Open Line Notification is OFF.

7 Inbound Tone Transfer is OFF.

8 Ring Reduction is OFF.

9 Outbound Tone Transfer is OFF.

39

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Lineshare Pro AC FCC Statement Lineshare PRO NOM Statement Trademarks Contents Lineshare PRO Specifications Before You Begin About the Lineshare ProLineshare PRO Installation Ports on the Lineshare ProRear Panel of the Lineshare Pro Telephone Wall Jack Volt TelephoneOutlet Wall Jack Connecting Telephone Equipment to the Lineshare Pro Outlet Lineshare Pro Installed on an Extension Lineshare PRO Lineshare PRO Phone Company Junction Box Red Green Installing the Lineshare Pro on a KSU or PBX System Lineshare Pro Installed on a KSU Or PBX Phone System Special Operating Notes Lineshare Pro Call RoutingLineshare PRO Answering Calls with a TAD Answering Incoming CallsAnswering Calls from Port Placing an Outbound Call Retrieving TAD Messages from a Remote LocationEmergency Call Override Sending a Fax Or Modem Transmission Receiving a Computer Call to a PortLineshare PRO Using Single-Frequency Tone Detection Lineshare PRO Using the Lineshare Pro’s Custom Features and Functions Lineshare Pro Features Feature Lineshare Pro Functions OFFFactory Setting Changing ON/OFF features Extension DetectionHome Routing Secured OperationNo Answer Cascade Answer/Disconnect CascadePulse Transfer Open Line Notification OLNInbound Tone Transfer Ring ReductionChanging Function Options Outbound Tone TransferProtocol Tone Access Signal Detection Dual Tone DetectionProtocol Tone Access Signal Assignment Keypad # Protocol Tone Access Signal Cascade Port Order Phantom Ring Style Emergency Call OverrideDual Tone Assignments Rings Available to the Ports Extension Detection TimerTime at Home 9 Reset to Factory Settings Rings to Answer CallCopyright 1996. Black Box Corporation. All rights reserved
Top Page Image Contents