Black Box FX150A manual Cascade Port Order

To select different protocol tones for all ports, press the following on your tone phone:

2 3 Protocol Tone Access Signal

0 Select all ports 1 through 4

The desired new protocol tones

*End programming sequence (3 beeps indicate correct entry)

(Optional entries for additional changes)

*Save changes and exit programming

NOTE

You must enter all four digits to associate a tone to each port. If you enter only one or two numbers, the Lineshare Pro will produce an error tone.

Do not assign a single protocol tone to more than one port. If you inadvertently assign a protocol tone to more than one port, the Lineshare Pro will produce an error tone.

LINESHARE PRO

[3] Cascade Port Order

Cascade Port Order operates only when the Lineshare Pro is configured in the non-secured mode.

This function sets the assigned order for the No Answer Cascade and Answer/Disconnect Cascade features.

The sequence of the Cascade Port Order can be set to default to any of the Lineshare Pro ports. The Cascade Port Order is factory-preset to 1 2 3 4 *.

To change the Cascade Port Order to reverse its default order

(4 3 2 1), enter the programming mode and press the following on your tone phone:

3Cascade Port Order

43 2 1 The desired new cascade order

*End programming sequence (3 beeps indicate correct entry)

(Optional entries for additional changes)

*Save changes and exit programming

47