Black Box FX150A manual Keypad # Protocol Tone Access Signal

Page 45

LINESHARE PRO

Table 5-3. Protocol Tone Access Signal Options.

	Keypad #	Protocol Tone Access Signal

	0	1000 Hz

	1	1100 Hz (typically fax CNG tone)

	2	1200 Hz

	3	1300 Hz

	4	1400 Hz

	5	1500 Hz

	6	1600 Hz

	9	2225 Hz (typically reverse modem tone)

The Protocol Tone Access Signal is factory-preset to 0 6 1 9 *. Protocol tone 0 will access Port 1, protocol tone 6 will access Port 2, protocol tone 1 will access Port 3, and protocol tone 9 will access Port 4.

To change Protocol Tone 4 to access a port, enter the programming mode and press the following on your tone phone:

2 3 Protocol Tone Access Signal

The desired port selection (1-4)

4The desired new Protocol Tone Access Signal

*End programming sequence (3 beeps indicate correct entry)

(Optional entries for additional changes)

*Save changes and exit programming

46

Image 45

Contents Lineshare Pro AC FCC Statement Lineshare PRO NOM Statement Trademarks Contents Lineshare PRO Specifications About the Lineshare Pro Before You BeginLineshare PRO Ports on the Lineshare Pro InstallationRear Panel of the Lineshare Pro Telephone Wall Jack Volt TelephoneOutlet Wall Jack Connecting Telephone Equipment to the Lineshare Pro Outlet Lineshare Pro Installed on an Extension Lineshare PRO Lineshare PRO Phone Company Junction Box Red Green Installing the Lineshare Pro on a KSU or PBX System Lineshare Pro Installed on a KSU Or PBX Phone System Lineshare Pro Call Routing Special Operating NotesLineshare PRO Answering Incoming Calls Answering Calls from PortAnswering Calls with a TAD Retrieving TAD Messages from a Remote Location Placing an Outbound CallEmergency Call Override Receiving a Computer Call to a Port Sending a Fax Or Modem TransmissionLineshare PRO Using Single-Frequency Tone Detection Lineshare PRO Using the Lineshare Pro’s Custom Features and Functions Lineshare Pro Features Feature OFF Lineshare Pro FunctionsFactory Setting Extension Detection Changing ON/OFF featuresSecured Operation Home RoutingAnswer/Disconnect Cascade No Answer CascadeOpen Line Notification OLN Pulse TransferRing Reduction Inbound Tone TransferOutbound Tone Transfer Changing Function OptionsDual Tone Detection Protocol Tone Access Signal DetectionProtocol Tone Access Signal Assignment Keypad # Protocol Tone Access Signal Cascade Port Order Emergency Call Override Phantom Ring StyleDual Tone Assignments Extension Detection Timer Time at HomeRings Available to the Ports Rings to Answer Call 9 Reset to Factory SettingsCopyright 1996. Black Box Corporation. All rights reserved