Black Box FX150A manual Changing ON/OFF features, Extension Detection

Page 37

LINESHARE PRO

The following sections contain specific information about each feature and function and how to change the setting.

5.4 Changing ON/OFF features

Earlier in this chapter, Table 5-1listed the features that can be turned ON or OFF individually, or simultaneously with other features during a single programming session. The features are numbered

[0]through [9]. In this section, you will find a description of each feature and instructions for turning the feature ON or OFF.

To turn a feature ON or OFF, use the following steps:

1.Press # * from a tone phone connected to Port 1 to enter the programming mode.

2.Turn the feature ON by pressing 1 followed by the feature number. Turn the feature OFF by pressing 0 followed by the feature number.

3.Press * to end the programming sequence.

4.Continue performing steps 2 and 3 until all the desired features have been changed.

NOTE

You have 5 seconds between each tone entry to enter another command. If you do not enter a command within 5 seconds, the Lineshare Pro exits the programming mode without saving the changes.

5.When you are finished making changes, press the * key again to save the changes and exit the programming mode.

Example: To turn Home Routing ON, enter the programming mode and press 1 1 *. Press * again to save the changes, and exit the programming mode. To turn Home Routing OFF, enter the programming mode and press 0 1 *. Press * again to save the changes, and exit the programming mode.

[0] Extension Detection

Extension Detection operates only when the Lineshare Pro is configured in the non-secured mode, and when an inbound telephone call is ringing PORT 1 (or the primary default port).

This feature allows the Lineshare Pro to detect when an extension phone not directly connected to the Lineshare Pro answers a call that is actively ringing the primary default port. When the Lineshare Pro detects that the extension phone has gone off-hook, it releases the call to the extension phone and stops ringing the primary default port.

The Extension Detection feature is

38

Page 36 Page 38
Image 37
Page 36 Page 38
Contents Lineshare Pro AC FCC Statement Lineshare PRO NOM Statement Trademarks Contents Lineshare PRO Specifications About the Lineshare Pro Before You BeginLineshare PRO Ports on the Lineshare Pro InstallationRear Panel of the Lineshare Pro Telephone Wall Jack Volt TelephoneOutlet Wall Jack Connecting Telephone Equipment to the Lineshare Pro Outlet Lineshare Pro Installed on an Extension Lineshare PRO Lineshare PRO Phone Company Junction Box Red Green Installing the Lineshare Pro on a KSU or PBX System Lineshare Pro Installed on a KSU Or PBX Phone System Lineshare Pro Call Routing Special Operating NotesLineshare PRO Answering Calls from Port Answering Incoming CallsAnswering Calls with a TAD Retrieving TAD Messages from a Remote Location Placing an Outbound CallEmergency Call Override Receiving a Computer Call to a Port Sending a Fax Or Modem TransmissionLineshare PRO Using Single-Frequency Tone Detection Lineshare PRO Using the Lineshare Pro’s Custom Features and Functions Lineshare Pro Features Feature OFF Lineshare Pro FunctionsFactory Setting Extension Detection Changing ON/OFF featuresSecured Operation Home RoutingAnswer/Disconnect Cascade No Answer CascadeOpen Line Notification OLN Pulse TransferRing Reduction Inbound Tone TransferOutbound Tone Transfer Changing Function OptionsDual Tone Detection Protocol Tone Access Signal DetectionProtocol Tone Access Signal Assignment Keypad # Protocol Tone Access Signal Cascade Port Order Emergency Call Override Phantom Ring StyleDual Tone Assignments Time at Home Extension Detection TimerRings Available to the Ports Rings to Answer Call 9 Reset to Factory SettingsCopyright 1996. Black Box Corporation. All rights reserved
Top Page Image Contents