Phantom Ring Style, Emergency Call Override

LINESHARE PRO

NOTE

You can enter one, two, three, or all four port numbers in this function. The Lineshare Pro will release a call after it reaches the last port in this sequence.

[4] Phantom Ring Style

When the Lineshare Pro answers a call, it produces a “phantom” ring signal. This tone is intended to make the switching process transparent to the caller. The Lineshare Pro has seven (7) different phantom ring types to choose from, allowing you to select a ring style similar to your local phone company’s ring signal.

The following ring types are available:

1U.S. style 1: 2-second ring, 4- second silence, dual tones

2Belgium style: 1-second ring, 3-second silence

3European style: 0.4-second ring, 0.2-second silence

4Special style: 1-second ring, 5-second silence

5U.K. style: 1.5-second ring, 1.5-second silence

6U.S. style 2: 2-second ring, 4- second silence, single-frequency low tone

7U.S. style 3: 2-second ring, 4- second silence, single-frequency high tone

The factory-preset Phantom Ring Style is U.S. style 1, 4 1 *.

To change the Phantom Ring Style, enter the programming mode and press the following on your tone phone:

4Phantom Ring Style The desired ring style

*End programming sequence (3 beeps indicate correct entry)

(Optional entries for additional changes)

*Save changes and exit programming

[5]Emergency Call Override

Emergency Call Override allows you to interrupt a call that is in process on either Port 2, Port 3, or Port 4.

The Emergency Call Override feature is factory-preset OFF, 5 0 *, and will not allow interruption of calls. When ON, this feature has two modes of operation as follows:

1Automatic

2Manual