Black Box FX150A manual Emergency Call Override

Page 27

LINESHARE PRO

During an outbound call, you can also receive a data or fax transmission from someone that is ready to transmit. To route this transmission from a tone phone to a specific port, press # 11 for Port 1,

#22 for Port 2, # 33 for Port 3, or

#44 for Port 4. To use this feature, you must first turn Outbound Tone Transfer ON. (See Section 5.4 for more information.)

4.8 Emergency Call Override

NOTE

This feature works in conjunction with the three- way calling service provided by the phone company. Three-way calling must be installed and in service on the phone line connected to the Lineshare Pro in order to interrupt a call and place an outbound emergency call.

When the Lineshare Pro is on line with a fax or data call through Port 2, Port 3, or Port 4, this feature allows a device connected to PORT 1 to disable the call. This feature is factory-preset OFF and must be turned ON in order to function.

When set to ON, this feature has two modes of operation as follows:

•In the Automatic mode of operation, the Lineshare Pro will interrupt a call already in process on Port 2, Port 3, or Port 4 if a phone device goes off-hook in PORT 1. When you take your phone off-hook for an emergency call, you will hear a four-second busy signal, a click, and then dial tone. Once you hear dial tone, you can dial your emergency number. If you do not receive dial tone after about five seconds, repeat the procedure.

•In the Manual mode of operation, the Lineshare Pro will interrupt a call already in process on Port 2, Port 3, or Port 4 if a phone device goes off-hook in PORT 1 and the * key is pressed. When you take your phone off-hook for an emergency call, you will hear a busy signal. If you want access to the line, press the * key. You then hear a click and dial tone. Once you hear dial tone, you can dial your emergency number. If you do not receive dial tone after about three seconds, hang up the phone and repeat the procedure.

To change the setting of this feature, see Section 5.4.

28

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Lineshare Pro AC FCC Statement Lineshare PRO NOM Statement Trademarks Contents Lineshare PRO Specifications About the Lineshare Pro Before You BeginLineshare PRO Ports on the Lineshare Pro InstallationRear Panel of the Lineshare Pro Telephone Wall Jack Volt TelephoneOutlet Wall Jack Connecting Telephone Equipment to the Lineshare Pro Outlet Lineshare Pro Installed on an Extension Lineshare PRO Lineshare PRO Phone Company Junction Box Red Green Installing the Lineshare Pro on a KSU or PBX System Lineshare Pro Installed on a KSU Or PBX Phone System Lineshare Pro Call Routing Special Operating NotesLineshare PRO Answering Incoming Calls Answering Calls from PortAnswering Calls with a TAD Retrieving TAD Messages from a Remote Location Placing an Outbound CallEmergency Call Override Receiving a Computer Call to a Port Sending a Fax Or Modem TransmissionLineshare PRO Using Single-Frequency Tone Detection Lineshare PRO Using the Lineshare Pro’s Custom Features and Functions Lineshare Pro Features Feature OFF Lineshare Pro FunctionsFactory Setting Extension Detection Changing ON/OFF featuresSecured Operation Home RoutingAnswer/Disconnect Cascade No Answer CascadeOpen Line Notification OLN Pulse TransferRing Reduction Inbound Tone TransferOutbound Tone Transfer Changing Function OptionsDual Tone Detection Protocol Tone Access Signal DetectionProtocol Tone Access Signal Assignment Keypad # Protocol Tone Access Signal Cascade Port Order Emergency Call Override Phantom Ring StyleDual Tone Assignments Extension Detection Timer Time at HomeRings Available to the Ports Rings to Answer Call 9 Reset to Factory SettingsCopyright 1996. Black Box Corporation. All rights reserved
Top Page Image Contents