Black Box FX150A manual Protocol Tone Access Signal Assignment

LINESHARE PRO

NOTE

Settings in this function do not affect the settings in the Dual Tone Assignments function.

Dual Tone Detection is factory- preset as follows (the first number is the corresponding port number; the second number is 0 for OFF, or 1 for ON):

1 1 * (Port 1 = ON)

2 1 * (Port 2 = ON)

3 1 * (Port 3 = ON)

4 1 * (Port 4 = ON)

To change one port to ignore dual tones, enter the programming mode and press the following on your tone phone:

2 2 Dual Tone Detection

The desired port selection (1-4)

0 Turn OFF

*End programming sequence (3 beeps indicate correct entry)

(Optional entries for additional changes)

*Save changes and exit programming

To change all ports to ignore dual tones, enter the programming mode and press the following on your tone phone:

2 2 Dual Tone Detection

0 Select all ports 1 through 4

0 0 0 0 All ports OFF

*End programming sequence (3 beeps indicate correct entry)

(Optional entries for additional changes)

*Save changes and exit programming

[2][3] Protocol Tone Access Signal Assignment

Protocol Tone Access Signal Assignment allows you to define the protocol tone access signal for each of the ports. You can enter a protocol tone access signal of 0-6 or 9 (see Table 5-3for information).

45