Lathem PC400TX manual Mount the Clock, Wall Mount To install the back box

Page 10

4 - PC400 Terminal Installation & User’s Guide

C H A P T E R 2

Mount the Clock

Find a suitable location where:

ƒTemperature stays within 32°-110° F

ƒHumidity remains below 95%

ƒNo excessive vibrations are present

ƒAn electrical outlet is within 4 feet

Note: Exposure to outdoor conditions, rain, snow, etc voids the warranty.

Wall Mount - To install the back box

Locate a flat wall surface. Place the back box on the wall 48 inches from the floor, with a pencil trace the outline where the 3 holes will be drilled.

Raised Strain Relief Points.

To use these, slide the tie wrap through the raised slot(s) and secure around cable and power cord.

Figure 1

Figure 1

Alternative Mounting: Install the back box directly to an electrical box.

Image 10
Contents Installation & User’s Guide PC400 & PC400TX TerminalFor Units Equipped with AN Internal Modem Getting Help Support InformationSupport Agreements N T E N T S Page Page Features and Specifications WelcomePower Surges and Spikes Main Application Files TERMMGR.EXEWall Mount To install the back box Mount the ClockPage Desktop Mount To install the back box RS-232 Connections Connect the Communication CablesTo make an RS232 connection RS-485 Connections To make an RS485 connectionModem Connections optional To make a Modem connectionPC400TX TCP/IP Connections optional To make a TCP/IP connectionBell Relay Connections To connect your signaling devices power sourceMaximum of 4 Bells / Horns Starting the Terminal Setup Mode Setup the ClockTo power up the clock To start the Terminal Setup Mode Select 0 PM / 1 AMPIN Entry SetupMode Using the Clock To punch using a badgeTo transfer Supervisor Mode Schedule OverrideManual Bell Ring Wiring Diagrams RS-232 to HostRS-485 Network Multi Drop Network using the SWIFT485+ PC400 Terminal Block Diagram Installing a Modem Module in the PC400 ¾ Remove the PayClock 400 Terminal from the Back BoxPage Installing a TCP/IP 10Base T Module in the PC400 ¾ Install the 10Base T ModulePC400 Terminal Installation & User’s Guide Replacing an Existing PayClock 2000 or PC100 PC400 Terminal Installation & User’s Guide Troubleshoot the Clock Ground screw and ground wire attached to back box Limited One-Year Limited Warranty Index