14 - PC400 Terminal Installation & User’s Guide
PIN Entry SetupMode
The PIN Entry Setup Mode allows you to enable or disable PIN entry from the keypad. PIN entry enables your employees to key in their badge number when punching instead of swiping their badge. With PIN entry enabled employees can do either, swipe their badge or key in their badge number.
To Enable PIN entry press 752902 on the keypad.
To Disable PIN entry press 752902 on the keypad.
Note: The 752902 code toggles PIN entry on or off. If you disable PIN entry, press [*] after the last digit is entered to return to a normal display
Press the Status button on the keypad to check your settings, this screen will display
| When PIN entry is enabled this screen will display: |
| PIN ENAB. |
| When PIN entry is disabled this screen will display: |
| PIN DISAB |
VER | Firmware version of your clock |
ID# | Number used to identify your clock |
MEM | Percentage of memory used |
UPD | Identifies the firmware patch version |
LOAD LIST | Ready to be updated from the PayClock software |
or |
|
CLK READY | Clock has been updated from the PayClock software and is ready to |
use |
|
BAUD | Baud rate setting 9600 or 2400 |
PIN | ENAB = enabled / DISAB = disabled |
DST | ON= Daylight savings is on / OFF = Daylight savings is off |
This completes the setup. The terminal is ready to accept a download. For more information on downloading to the PC400/PC400TX see the PayClock software users guide or the on line help.
Note: If your PC400TX was discovered and configured using the Terminal Manager software you will see the terminals IP address display after the above Status screen.