Lathem PC400TX manual To start the Terminal Setup Mode, Select 0 PM / 1 AM

Page 19

PC400 Terminal Installation & User’s Guide - 13

Note: The first time the PC400/PC400TX is powered up it will go into the Terminal Setup Mode automatically.

Terminal Setup Mode

Use the terminal setup mode to set the time, date, baud rate and terminal ID # for the terminal.

*NOTE* You can exit the terminal setup mode at any time by pressing the [*] Exit key.

To start the Terminal Setup Mode

Press 729255 on the keypad to enter the “Terminal Setup” function. The terminal displays

ENT.DATE: MM-DD-YYYY

Enter the current date and press # [enter]. The terminal displays

ENTER DAY-OF-WEEK: D 1=SUNDAY..7=SATURDAY

Enter the number that represents the current day of the week. The terminal displays

ENTER TIME: HH:MM

Enter the current time and press # [enter]. The terminal displays

SELECT [0] PM / [1] AM

Press 0 to select PM or 1 to select AM. The terminal displays

PRESS [#] IF CORRECT

Press # [enter]. The terminal displays

COMMUNICATIONS SETUP SELECT BAUD RATE: [2]400 -OR- [9]600

Press 2 to select 2400 or 9 to select 9600 (required for PC400TX). The terminal displays

ENTER TERM ID# 049 (049 is the default setting)

Enter the number for the terminal ID and press # [enter] and then press # [enter] again.

Note: Valid ID’s are 1 – 250 excluding 58.

The terminal will go to the normal time and date display

Image 19 Lathem PC400TX manual To start the Terminal Setup Mode, Select 0 PM / 1 AM
Contents PC400 & PC400TX Terminal Installation & User’s GuideFor Units Equipped with AN Internal Modem Getting Help Support InformationSupport Agreements N T E N T S Page Page Welcome Features and SpecificationsPower Surges and Spikes TERMMGR.EXE Main Application FilesMount the Clock Wall Mount To install the back boxPage Desktop Mount To install the back box RS-232 Connections Connect the Communication CablesTo make an RS232 connection To make an RS485 connection RS-485 ConnectionsTo make a Modem connection Modem Connections optionalTo make a TCP/IP connection PC400TX TCP/IP Connections optionalBell Relay Connections To connect your signaling devices power sourceMaximum of 4 Bells / Horns Starting the Terminal Setup Mode Setup the ClockTo power up the clock Select 0 PM / 1 AM To start the Terminal Setup ModePIN Entry SetupMode To punch using a badge Using the ClockTo transfer Schedule Override Supervisor ModeManual Bell Ring RS-232 to Host Wiring DiagramsRS-485 Network Multi Drop Network using the SWIFT485+ PC400 Terminal Block Diagram ¾ Remove the PayClock 400 Terminal from the Back Box Installing a Modem Module in the PC400Page ¾ Install the 10Base T Module Installing a TCP/IP 10Base T Module in the PC400PC400 Terminal Installation & User’s Guide Replacing an Existing PayClock 2000 or PC100 PC400 Terminal Installation & User’s Guide Troubleshoot the Clock Ground screw and ground wire attached to back box Limited One-Year Limited Warranty Index