Lathem 6000E manual Lathem Time Corporation

Page 2

WARNING

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his or her own expense.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS A LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE RADIO INTERFERENCE REGULATIONS OF THE CANADIAN DEPARTMENT OF COMMUNICATIONS.

LE PRÉSENT APPAREIL NUMÉRIQUE N'ÉMET PAS DE BRUITS RADIOÉLECTRIQUES DÉPASSANT LES LIMITES APPLICABLES AUX APPAREILS NUMÉRIQUES DE CLASSE A PRESCRITES DANS LE RÈGLEMENT SUR LE BROUILLAGE RADIOÉLECTRIQUE ÉDICTÉ PAR LE MINISTÈRE DES COMMUNICATIONS DU CANADA.

1.The details of this User's Manual are subject to change even without previous notification.

2.This User's Manual has been prepared with the utmost care to cover all aspects of the time clock's use.

3.Be sure to use your time clock after you have fully understood the hardware and software specifications and limits.

4.No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, mechanical, photocopying, recording or otherwise.

This User's Manual and its contents are copyrighted by LATHEM TIME CORP. with all rights reserved.

Lathem Time Corporation

www.lathem. com

(800)241-4990

(404)691-1065

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Lathem Time Corporation Lathem Time Corporation Table of Contents Precautions SignsDaily Care Features Daylight saving time indication Day of the week indication AccessoriesLocation of Controls Installing Ribbon Cassette Panel open buttonMounting Unit on Wall Environmental ConditionsSetting Daily OperationsTo prepare for setting Unlock the unit. While holding down SettingPreparation for setting Key hole Panel house Display2EMOVE the Panel COVER Setting Pay Ending and Card / Print LanguageMonthly Closing Stays LIT UPPrint language Day of the week Weekly ClosingToday is printed on the second line from the top Bi-Weekly Closing Bi-weekly closingEnglish DATE/TIME 12/24 Hour formatSelect English Press or Setting the Day Advance Time$A Aadvancedtime To cause digits to flash, and then press orSetting the Daylight Saving Time D.S.T Daylight saving time function3ETTINGTTHENSTARTTDATE Month and DA3TARTADATE OFD$34 1/60 To Select ThehHow to Cancel D.S.T. Settings End dateSetting the Time Table Program EXT DAYPrint color 00 Black 01 Red External time signal Column Disabled no setting EnabledFollow the steps to set time table programs Time to be setAbove Print color With P-01 flashing, press Once Print in redTo set P-01 shown in the table Lower left of the display Represents print in black PressErase under TU MinuteErase under MO Erase under MO SA Staying lit upUnder MO-SA lit up External 1/60 time signal 1/100Make the bars Print in black1/100To erase program settings To check program settingsTo modify program settings Indication at84 !,!2 Press Select to cause EXT. Alarm to light upSEC DS Resetting Screw Connection Specifications for External ContactOttom 6IEW Maximum of 8 bells/horns typicalInstalling Ni-Cd Battery optional Other failures TroubleshootingError No. appears Temperature -5˚ to + 45˚C SpecificationsExternal time signal ConnectionTime Card Specifications Semi-Monthly Card Q0086 6120
Top Page Image Contents