Lathem 6000E manual Installing Ni-Cd Battery optional

Page 32

7. INSTALLING Ni-Cd BATTERY (optional)

Follow the steps below to install a Ni-Cd battery (optional) in case of power failure.

1 Unscrew the screw that holds the lid of the battery compartment in the lower right-hand corner of the back of

the unit.

Screw

2 Insert the battery connector into the compartment connector to install the battery.

Connector

3 Hook the lid to close, and secure it with the screw.

Use only the originally offered

Ni-Cd Battery.

29

Image 32

Contents Lathem Time Corporation Lathem Time Corporation Table of Contents Precautions SignsDaily Care Features Daylight saving time indication Day of the week indication AccessoriesLocation of Controls Installing Ribbon Cassette Panel open buttonMounting Unit on Wall Environmental ConditionsSetting Daily OperationsSetting Preparation for settingTo prepare for setting Unlock the unit. While holding down Key hole Panel house DisplaySetting Pay Ending and Card / Print Language Monthly Closing2EMOVE the Panel COVER Stays LIT UPPrint language Day of the week Weekly ClosingToday is printed on the second line from the top Bi-Weekly Closing Bi-weekly closingEnglish DATE/TIME 12/24 Hour formatSelect English Setting the Day Advance Time $A AadvancedtimePress or To cause digits to flash, and then press orSetting the Daylight Saving Time D.S.T Daylight saving time functionMonth and DA 3TARTADATE OFD$34 1/603ETTINGTTHENSTARTTDATE To Select ThehHow to Cancel D.S.T. Settings End dateSetting the Time Table Program EXT DAYExternal time signal Column Disabled no setting Enabled Follow the steps to set time table programsPrint color 00 Black 01 Red Time to be setPrint in red To set P-01 shown in the tableAbove Print color With P-01 flashing, press Once Lower left of the display Represents print in black PressErase under TU MinuteErase under MO Erase under MO SA Staying lit upExternal 1/60 time signal 1/100 Make the barsUnder MO-SA lit up Print in black1/100To check program settings To modify program settingsTo erase program settings Indication at84 !,!2 Press Select to cause EXT. Alarm to light upSEC DS Resetting Connection Specifications for External Contact Ottom 6IEWScrew Maximum of 8 bells/horns typicalInstalling Ni-Cd Battery optional Other failures TroubleshootingError No. appears Specifications External time signalTemperature -5˚ to + 45˚C ConnectionTime Card Specifications Semi-Monthly Card Q0086 6120