www.axxessid.com
Installation & User Guide
Sensor’s specifications are displayed at the top of the screen. You could specify how frequent you would like the sensor to take readings and how often you’d like the readings to be reported. All the reported and unreported data will be stored in the log file and can be accessed via the report section.
If the Alarm on Fault/Fire is ticked, once there is a fire or fault in the unit, an alarm transaction will be generated and displayed on he main screen. This message will include the
Isolate
In order to switch on the isolate, click on the advanced button. The output settings are located on the bottom of the screen. The software will ask you to enter a brief explanation called “permit to work” before switching on the isolate. The software reports the isolate state by showing a flashing icon below the controller buttons on the main screen.
Please note that the Isolate is considered an alarm condition so as long as the unit is in isolate the sensor’s symbol in the environment screen will remain amber, even if all the other alarms have been cleared!
Once you switch on the isolate the isolate light on the Redetec unit comes on. Please note that the isolate command from the software overrides the position of the keys switch.
AX200 Installation & User Guide – July 2007 | 9 8 |