Ricoh VT1730 manual Daily Maintenance

Page 38

Thermal Head

DAILY MAINTENANCE

4.While pushing out the platen roller release levers (located on both sides of the feed roller), grip both ends of the feed roller and lift it straight up.

5.Clean the thermal head as follows:

(1)Wipe the surface of the thermal head with a damp cloth.

(2)Clean the surface of the thermal head several times using the cleaner pen with cleaning solution. (The cleaner pen is stored in the carton box as an accessory.)

(3)Dry the surface of thermal head with a clean dry cloth.

~Make sure to put the cap back onto the cleaning solution bottle.

~Replace the felt of the cleaner pen if it becomes dirty.

6.Grip the platen roller release levers, and put the feed roller back in its original position. While pushing

the right platen roller release lever strongly until it is set completely, set the platen roller release levers in its original position.

7.Place the master roll back in its original position. See page 6.

37

Image 38

Contents Priport VT1730 Table Completed prints are delivered here. See Major ComponentsMachine Exterior Operation Panel = KeysPress to enter When the Master Making key isStop making a master, the ~+ Will not continue making the masterEnvironments To Avoid Installation RequirementsMachine Environment Optimum environmental conditionsPower Connection Access To The MachineSupplying the Master ROLL, INK, and Tape Supplying The Master RollPage Remove the cut-off portion of the master roll Close the top coverSupplying Ink Close the ink cover Option Supplying Tape For The Tape D~penser Option Operation Operation Loading paper ClWhen you load thick and small paper, seePreparation For Printing Place the paper on the paper feed table Setting up the paper delivery table Adjust the paper delivery rollers to match the paper size Lbc-&55iihUsing the Number keys, enter the number of prints required Standard PrintingPress the Print Start key Remove the prints from the paper delivery table Restoring The Paper Feed And Paper Delivery Tables Page Press the right or left Image Position key Adjusting The Image PositionShifting the image position forward or backward Press the Proof key. Check the image positionShifting the image to the right or left Operation Adjusting The Image Density LighterChanging The Printing Speed To Stop The Machine During a Printing Run Making Master And Prints Automatically Group Printing From The Same Original Class Mode With the Number keys, enter the desired number of sets Group Printing From Different Originals Memory Mode Press the Enter key again. The memory returns to Memory Set the originals face down on the original tablePhoto Mode Printing Daily Maintenance Thermal HeadDaily Maintenance Contact Glass Paper Feed Roller Paper Delivery Rollers Exit Sensor Drum Clamper Troubleshooting $~+FWhen Other Indicators Light When the Open Cover/Unit Indicator ~ LightsWhen the Supply/Exchange Indicators Light ~+AOpen the ADF rover Pull out the original gently When The Misfeed Indicator + Lights++ a Original ++ B Paper misfeed in paper feed section Troubleshooting ++ c MaSter misfeed in master feed section II ++ E Paper wrapping around the drum When The Misfeed Indicator Liahts To remove misfed sheets of paper Close the top cover + G Paper misfeed in the paper exit section When The Open Cover/Unit Indicator ~ Lights When The Supply/Exchange Indicators Light Remove the used mastersWhen Other Indicators Light Poor Printing Thermal head SeeOperation Notes Operating Cautions General CautionsIf your hands are stained with ink Specifications Mm, 3.5 xOptional Equipment Consumables Weight 51kg L121b Power SourceNoise Emission