Ricoh VT1730 manual Lbc-&55iih, Adjust the paper delivery rollers to match the paper size

Page 19

OPERATION

4.Adjust the paper delivery rollers to match the paper size,

D Ifyoupositionthepaperdeliveryrollerson the print area, each roller will make a line on the paper.

Cl You should leave margins of more than 5 mm, 1/5” on the rightand left sides of the paper because the rollers track those areas.

OThe paper delivery rollers may not feed properly and a misfeed may occur if the print contains a large solid fill image.

In such cases, leave margins of approximately 10 mm, 2/5 on both edges and move the rollersfurther away from the edges.

Caution: Do not touch the paper delivery rollers while the machine is operating, or the machine will be damaged.

Preparation For Printhq

lbc-&55iih I

)+ II

I

Image 19

Contents Priport VT1730 Machine Exterior Major ComponentsTable Completed prints are delivered here. See = Keys Operation PanelWill not continue making the master When the Master Making key isStop making a master, the ~+ Press to enterOptimum environmental conditions Installation RequirementsMachine Environment Environments To AvoidAccess To The Machine Power ConnectionSupplying The Master Roll Supplying the Master ROLL, INK, and TapePage Close the top cover Remove the cut-off portion of the master rollSupplying Ink Close the ink cover Option Supplying Tape For The Tape D~penser Option Operation Operation Preparation For Printing ClWhen you load thick and small paper, see Loading paper Place the paper on the paper feed table Setting up the paper delivery table Lbc-&55iih Adjust the paper delivery rollers to match the paper sizeStandard Printing Using the Number keys, enter the number of prints requiredPress the Print Start key Remove the prints from the paper delivery table Restoring The Paper Feed And Paper Delivery Tables Page Press the Proof key. Check the image position Adjusting The Image PositionShifting the image position forward or backward Press the right or left Image Position keyShifting the image to the right or left Operation Lighter Adjusting The Image DensityChanging The Printing Speed To Stop The Machine During a Printing Run Making Master And Prints Automatically Group Printing From The Same Original Class Mode With the Number keys, enter the desired number of sets Group Printing From Different Originals Memory Mode Set the originals face down on the original table Press the Enter key again. The memory returns to MemoryPhoto Mode Printing Thermal Head Daily MaintenanceDaily Maintenance Contact Glass Paper Feed Roller Paper Delivery Rollers Exit Sensor Drum Clamper $~+F Troubleshooting~+A When the Open Cover/Unit Indicator ~ LightsWhen the Supply/Exchange Indicators Light When Other Indicators Light++ a Original When The Misfeed Indicator + LightsOpen the ADF rover Pull out the original gently ++ B Paper misfeed in paper feed section Troubleshooting ++ c MaSter misfeed in master feed section II ++ E Paper wrapping around the drum When The Misfeed Indicator Liahts To remove misfed sheets of paper Close the top cover + G Paper misfeed in the paper exit section When The Open Cover/Unit Indicator ~ Lights Remove the used masters When The Supply/Exchange Indicators LightWhen Other Indicators Light Thermal head See Poor PrintingOperation Notes General Cautions Operating CautionsIf your hands are stained with ink Mm, 3.5 x SpecificationsNoise Emission Weight 51kg L121b Power SourceOptional Equipment Consumables