Ricoh VT1730 manual Place the paper on the paper feed table

Page 17

OPERATION

Preparation For Printing

4.Place the paper on the paper feed table.

~Make sure every sheet in the stack is set evenly. This helps prevent paper skewing.

CJ Make sure the leading edge of the staok is in full contact with the front board.

0500 sheets of paper can be loaded at a time. If you load more than 500 sheets, paper may not be fed properly.

~Do not stack paper over the paper feed side plates.

5.Lift the feed roller pressure lever.

Caution: Be careful not to catch your finger between the /ever and the side paneL

6.Make sure that the paper feed side plates contact the paper gently.

O The paper feed side plates should be parallel to the sides of the paper stack, othenvise the paper might not be fed correctly.

Printing on thick and small paper

		r				I
Set the side pads before adjusting the
paper feed side plates to match the
paper	size.			LI -
		l-m-	11	LI -
Thick	and small paper:		J	,L3	II	II I
Heavier than 150		g/mz, 39.9 lb
Smaller than 210		x 150 mm,
	8.3” X 5.9”

16

.. ..

Image 17

Contents Priport VT1730 Table Completed prints are delivered here. See Major ComponentsMachine Exterior = Keys Operation PanelStop making a master, the ~+ When the Master Making key isPress to enter Will not continue making the masterMachine Environment Installation RequirementsEnvironments To Avoid Optimum environmental conditionsAccess To The Machine Power ConnectionSupplying The Master Roll Supplying the Master ROLL, INK, and TapePage Close the top cover Remove the cut-off portion of the master rollSupplying Ink Close the ink cover Option Supplying Tape For The Tape D~penser Option Operation Operation Loading paper ClWhen you load thick and small paper, seePreparation For Printing Place the paper on the paper feed table Setting up the paper delivery table Lbc-&55iih Adjust the paper delivery rollers to match the paper sizeStandard Printing Using the Number keys, enter the number of prints requiredPress the Print Start key Remove the prints from the paper delivery table Restoring The Paper Feed And Paper Delivery Tables Page Shifting the image position forward or backward Adjusting The Image PositionPress the right or left Image Position key Press the Proof key. Check the image positionShifting the image to the right or left Operation Lighter Adjusting The Image DensityChanging The Printing Speed To Stop The Machine During a Printing Run Making Master And Prints Automatically Group Printing From The Same Original Class Mode With the Number keys, enter the desired number of sets Group Printing From Different Originals Memory Mode Set the originals face down on the original table Press the Enter key again. The memory returns to MemoryPhoto Mode Printing Thermal Head Daily MaintenanceDaily Maintenance Contact Glass Paper Feed Roller Paper Delivery Rollers Exit Sensor Drum Clamper $~+F TroubleshootingWhen the Supply/Exchange Indicators Light When the Open Cover/Unit Indicator ~ LightsWhen Other Indicators Light ~+AOpen the ADF rover Pull out the original gently When The Misfeed Indicator + Lights++ a Original ++ B Paper misfeed in paper feed section Troubleshooting ++ c MaSter misfeed in master feed section II ++ E Paper wrapping around the drum When The Misfeed Indicator Liahts To remove misfed sheets of paper Close the top cover + G Paper misfeed in the paper exit section When The Open Cover/Unit Indicator ~ Lights Remove the used masters When The Supply/Exchange Indicators LightWhen Other Indicators Light Thermal head See Poor PrintingOperation Notes General Cautions Operating CautionsIf your hands are stained with ink Mm, 3.5 x SpecificationsOptional Equipment Consumables Weight 51kg L121b Power SourceNoise Emission