Ricoh VT1730 manual + G Paper misfeed in the paper exit section

Page 54

When The Misfeed Indicator Lights

TROUBLESHOOTING

“:% + G “ Paper misfeed in the paper exit section

1.Remove the misfed paper.

~Open the top cover or paper delivery fence if it is necessary.

2.Press the Reset key.

—To prevent paper misfeed:

#Check the position of the paper delivery rollers. See page 18.

Cl If the exit sensor is dim with paper dust, clean it. See page 41.

~If there is a Iar e solid fill image on the leading edge of the original, set the original so that its lea 3 mg edge becomes the trailing edge. Altemativel , change the Image position and make a margin of more than 5 mm, 1/5” at the lea J ing edge of prints.

IJ Try to change the printing speed.

~When you set a curled paper, mrrect the face curl of the leading edge of the paper as shown below.

-FeedDirection

53

Image 54

Contents Priport VT1730 Major Components Machine ExteriorTable Completed prints are delivered here. See Operation Panel = KeysPress to enter When the Master Making key isStop making a master, the ~+ Will not continue making the masterEnvironments To Avoid Installation RequirementsMachine Environment Optimum environmental conditionsPower Connection Access To The MachineSupplying the Master ROLL, INK, and Tape Supplying The Master RollPage Remove the cut-off portion of the master roll Close the top coverSupplying Ink Close the ink cover Option Supplying Tape For The Tape D~penser Option Operation Operation ClWhen you load thick and small paper, see Preparation For PrintingLoading paper Place the paper on the paper feed table Setting up the paper delivery table Adjust the paper delivery rollers to match the paper size Lbc-&55iihUsing the Number keys, enter the number of prints required Standard PrintingPress the Print Start key Remove the prints from the paper delivery table Restoring The Paper Feed And Paper Delivery Tables Page Press the right or left Image Position key Adjusting The Image PositionShifting the image position forward or backward Press the Proof key. Check the image positionShifting the image to the right or left Operation Adjusting The Image Density LighterChanging The Printing Speed To Stop The Machine During a Printing Run Making Master And Prints Automatically Group Printing From The Same Original Class Mode With the Number keys, enter the desired number of sets Group Printing From Different Originals Memory Mode Press the Enter key again. The memory returns to Memory Set the originals face down on the original tablePhoto Mode Printing Daily Maintenance Thermal HeadDaily Maintenance Contact Glass Paper Feed Roller Paper Delivery Rollers Exit Sensor Drum Clamper Troubleshooting $~+FWhen Other Indicators Light When the Open Cover/Unit Indicator ~ LightsWhen the Supply/Exchange Indicators Light ~+AWhen The Misfeed Indicator + Lights ++ a OriginalOpen the ADF rover Pull out the original gently ++ B Paper misfeed in paper feed section Troubleshooting ++ c MaSter misfeed in master feed section II ++ E Paper wrapping around the drum When The Misfeed Indicator Liahts To remove misfed sheets of paper Close the top cover + G Paper misfeed in the paper exit section When The Open Cover/Unit Indicator ~ Lights When The Supply/Exchange Indicators Light Remove the used mastersWhen Other Indicators Light Poor Printing Thermal head SeeOperation Notes Operating Cautions General CautionsIf your hands are stained with ink Specifications Mm, 3.5 xWeight 51kg L121b Power Source Noise EmissionOptional Equipment Consumables