Ricoh 1008, FT1208 manual

Page 47

When using transparencies, set one sheet at a time into the bypass feed and open the copy tray. Remove copies delivered to the copy tray one by one. When you use translucent paper in low-temperature and low-humidity conditions, it may be misfed. Set the paper aside with paper curl face down until paper is flat with surface. Set one sheet at a time into the bypass feed. Then, deliver the paper to the copy tray.

Under the following conditions, you might get light copies:

-When you make 150 or more copies continuously.

-When you make solid full image copies.

-When you make copies while the Replenish Toner I_& indicator is blinking. Copies may be curled after coming out of the

copier. If necessary, uncurl the paper within 5mm (0.2 in.) of its edges, as shown, before inserting it in the bypass feed to make a two- sided copy.

Keep the used toner cassette horizontal. If you tilt the unit, toner may spill. Do not store the toner cassette in high-temperature and high-humidity condi- tions.

If you make copies continuously under high temperatures, the copier may stop to prevent overheating. The Start indicator will turn red and “ti :” is displayed on the copy counter. In this case, let the copier cool down, and wait until the Start indicator turns green.

When you replace the toner cassette and close the top unit, press down firmly on the marked position.

While copying, do not turn off the main switch. While copying, do not open the top unit.

While copying, do not lift the platen cover. While copying, do not unplug the power cord.

Do not lay anything weighing more than 10kg (22 lb) on the exposure glass. Do not place tools or other hard objects on the exposure glass.

Do not allow paper clips, staples, or other small metallic objects to fall inside the copier.

Always turn the copier off when you have finished copying for the day.

48

Image 47
Contents Ricoh FT1008/1208 For details, see pages Essential Symbols Page Power cord Main Switch Guide Plates Qpe1&2 Press to reduce/enlarge copies in preset ratios. See 20-21 Clearing Misfeeds Saving power Auto-off mode -for automaticallyPage Page Remove the toner cassette from the vinyl bag Adjusting the paper width Adjusting the paper lengthPage Confirm that the copy tray is securely in place Turning Copier On Power ConnectionAuto-off mode for automatically saving power Copier Location Bypass Feed Copying Alignment of Originals ++ +o Align the center of the original to the arrow mark Two-sided copies TransparenciesLetterhead Page Page Page Press the Start key to make the first copy Page Page Page User Tool Adjustable item See Number Page Auto image density levelUser mode Adjusting values/modesDarker-side manual image density level User mode Auto reset durationUser mode Page Copy Yield Maintaining the CopierKeep the vinyl bag for repacking Page Platen Cover P y Tray Bypass Feed Page Keep this tool inside the copier Attension Make sure to press the marked position Page Page Page Page Put the toner cassette in a vinyl bag Put the copier in the cardboard box When & stays on When Pz appears on the copy counterCondition Cause Remedy See Condition Cause Remedy PZe Page When PE appears on the copy counter When & is lit Specifications Originals ConfigurationCopy Paper Weight Copy ProcessDimensions Page Page Page EE@rnm~