Mitsubishi Electronics DX-TL950E Specifications, Connectors, Gnd, Call OUT/CALL OUT GND, 10BASE-T

Page 90

Specifications

Rated Power Supply:

Rated Input:

Color System:

Operating Temperature:

Relative Humidity:

Altitude:

Dimensions:

Weight:

Recording System

Sampling

Data Compression

Compression Unit

Resolution

Recording Device

Video Input:

Monitor Output:

Throughout Output:

Audio Input:

Audio Output:

Microphone Input:

Timer Program:

Memory Backup:

CONNECTORS

ALARM IN(1-9) Input:

CLOCK ADJ Input:

REC Input:

EMERGENCY Input:

GND:

MODE OUT(1-5) Output:

DC 12V OUT Output:

CALL OUT/CALL OUT GND:

Rating:

MODE OUT(1-5)

ALARM IN / CLOCK ADJ / REC/EMERGENCY

CALL OUT /

CALL OUT GND

RS-232C

ETHERNET

AC 100-240V 50/60Hz

0.60- 0.30A (100-240V) PAL type color system.

41° F-104°F (5° C to 40° C). Max.80(%)

Max.2000(m)

300(Width) x 350(Depth) x 88(Height)(mm). 5.0kg

Digital recording method using WAVELET compression. 13.5MHz

WAVELET Field

684 x 288

250GB HDD or higher

9

Input BNC-Connector:

1.0 V(p-p), 75 ohms.

S-Connector:

Y-Signal: 1.0 V(p-p), 75 ohms.

 

 

C-Signal: 0.3 V(p-p), 75 ohms.

2

Output BNC-Connector:

1.0 V(p-p), 75 ohms.

RCA-Pinplug:

1.0 V(p-p), 75 ohms.

9

Output BNC-Connector:

1.0 V(p-p), 75 ohms.

RCA-Pinplug:

308 mV(rms), 50 kohms.

2

Output RCA-Pinplug:

308 mV(rms), 1 kohms.

Ø 3.5mm minijack:

0.346 mV(rms), 600 ohms.

8 programs-Daily start and stop time for one week x 3set. Lasts for more than 1 month.

Terminal for starting alarm recording.

Terminal for adjusting clock.

Terminal for start recording.

Terminal for start emergency recording.

Terminal for ground.

Terminal for indication of recording selected mode.

Terminal for DC 12V OUT. Max. Drive current 350mA DC. ( 350mA : 11.5 V typ ± 1.5 V ) Terminal for external warning device.

Active:

“Low” Level.

Max. Drive current 7mA DC.

Non active:

Open.

Max. Voltage +24V DC.

Active:

When terminals are short-circuited

 

or “Low” Level voltage is applied.

Non active:

Open.

 

Active:

ON.

Max. Drive current 7mA DC.

Non active:

Open.

Max. Voltage +24V DC.

RS-232C (D-SUB 9pin) connector for connection with personal computer.

Connector form:

RJ-45

Physical interface:

10BASE-T

Accessories

 

AC power cord (for U.K / for the Continent)

2

COMPACT FLASH slot cover (mounted on unit)

1

Compact Flash Card recording format

Original format (FSM2)

Weight and dimensions shown are approximate.

Design and specifications are subject to change without notice.

SLD Security & Communications

The Old Forge, Ockham Lane, Ockham, Surrey GU23 6PH England Phone +44.1483225633 · Fax +44.1483225634 sales@sld.co.uk · www.sld.co.uk

••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••Specifications

90

Image 90
Contents DX-TL950E Recording FeaturesBuilt-in duplex 9 channel multiplexer NetworkEase of use Auto set-upProtect the Power Cord When not in use always turn OFF the Main switchMains Lead Connection Contents 67-71 60-6365,66 72,73Flowchart Flowchart for connection and settingsAuto SET UP Setting the timer recording Setting other various functionsSetting the motion detection Timer recording is executed/completedMajor operations and their functions Analogue OUT connectors Emergency indicatorLock indicator Front View Inside of the doorMajor operations and their functions Alarm Interrupt buttonSET UP button Search buttonCamera in connectors Main switchVideo OUT connectors Camera OUT connectorsRS-232C connector Ethernet connectorConnecting to Cctv camera, monitor, sensor ConnectionsAlarm Recording Connection Connecting with analog video recorderConnections Auto SET UP Turn the Shuttle ring clockwiseWhen the setting is complete, press the Power button Auto SET UP / Initial settingsHDD Setting InitializationMenu settings Basic OperationsMultiplexer functions Time Date Adjust Daylight SAVING/DAYLIGHT SettingDefault SUN, LAST, MAR Basic OperationsBasic manual recording Present time displayRecorded capacity display function SUPER, HIGH, STDSTANDARD, BASIC, Long ShortLong To change HDD or Compact Flash Card playback device Basic playbackBack repeatedly see HDD Repeat PLAY, Press the Play buttonTo pause playback, press the Pause button Basic searchTime Date Search To stop playback, press the Stop buttonEnglish , Francais , Deutsch For playback, see Various playback func- tions, pages 65,66Language Selection Españ OL, PyCCKNN, ItalianoMain Menu Menu SettingMenu functions SUB MenuSET UP Initial SET UP/INFORMATION HDD Settings Menu functionsMain Menu SUB Menu REC/STOP + Power button Copy Menu Search Selection MenuCamera TITLE/MEMO Setting Time Date AdjustDisplay Mode Clock Location SettingRepeat steps 2 ~ 6 to input Counter in the camera number Camera TITLE/MEMO Setting screen appearsDisplay returns to the Camera TITLE/MEMO Setting screen Appears in reversed color on the very left of the stringDuplex Mode Display Setting default BottomSPLIT/SEQUENCE button operations Plexer can also be found on seeCamera number button operations Available modesMPX Display Settings ZoomSPLIT9 Screen Setting MPX Display SettingsSPLIT4 Screen Setting For the SPLIT9 Screen SETTING, SPLIT9 screen can be setSequence Setting Interlace3 , 4 , 5 , 6 , 7 Selection Camera Number Detection Mask SettingSetting default 3 , 4 , 5 , 6 , 7 , 8 Nected camera, are setSensitivity Motion Detection SettingsTest Mode Motion ThresholdWhen setting the camera selection during alarm recording Settings concerning normal recording and alarm recordingIng pre-alarm recording, see Alarm SettingRecord Settings About alarm recordingPicture quality for normal recording pages 22,23 Recording time during alarm recording can be set Alarm REC DurationPRE Alarm REC Pre-alarm recording can be setTimer Program Settings Timer ProgramStructure of the Timer Program screen Press the Timer button Cerning recording mode settings, see pages 22,23 Timer Program SettingsHoliday Setting Overlapping Timer settingsHDD Repeat Play HDD Settings HDD Repeat REC MAIN/HDD Repeat REC SUBSetting default OFF IM-CHECK PlayAudio Recording Initial SET UP/INFORMATIONSequential Play Single screen sequential playback startsRear Terminal Settings Mode OUT 1 ~ Mode OUT KEY SoundBuzzer Call OUT Settings Setting of Device default MainSetting of Remain HDD default 10% Remain HDDHDD Main FULL/HDD SUB Full Communication Port SettingsRS-232C Emergency REC DurationSettings EthernetMail Address Service Port Setting Alarm Notification SettingINFORMATION/SERVICE 2/2 INFORMATION/SERVICEINFORMATION/SERVICE 1/2 Setting is confirmed and stops flashingReset to Factory Settings Menu screen settings are reset Menu screen settings are resetData Clear Password Password LockSimple Lock To unlock the Password for level Press the SET UP button To unlock the PasswordInput the Password entered in First in Second Repeat steps 2-2 ~ 2-4 to set level 2 and levelTo change the Password Changing from Password Lock mode to Simple Lock modeTo lock the Password only level1 to level Press the Warning Reset buttonTo save menu settings of this unit to a Compact Flash Card Quick SettingsTo update menu settings of this unit Quick Settings screen appearsOperation example SettingOperation examples OperationHoliday Setting 31/12, 01/01, 02/01, 03/01 This example uses the holiday settingHDD Settings screen setting see pages 47,48 Camera number 1 ~ Input titleRecord Setting C screen setting see REC Mode C screen setting seeAlarm Setting C screen setting see Operation examplesRecord Setting C REC Mode D screen setting seeRecord Setting D screen setting see Alarm Setting DVarious recordings PRE Alarm RecordingsPre-alarm recording Emergency RecordingsVarious playback functions Simultaneous playback during recording Press the REV. Play Reverse Playback buttonVarious search Search SelectionTime Date Search Press the Search button Index SEARCH/ALARM Index SearchVarious search Playback the search resultAlarm Skip Search Alarm Skip Search In the case of forward directionTo clear the search screen, press the Search button twice Alarm List Search To clear the alarm list, erase the dataSTART/END Search Press either the Play REV. Play or Pause buttonSearch screen selected in previous Search Type appears Making Copy/Restore Menu changes to Restore when CFC Main HDD is selectedAn end. Be careful Video Cord Audio Cord Copying from unit to videotapeBack see Sequential PLAY, Analogue Video Cassette RecorderHDD Setting Power failure compensation circuitPower failure reset recording Other convenient functionsPartition Size setting appears on the Initialization screen Points to be aware of regarding Mirror modePoints to be aware of regarding Partition mode PARTITION/PARTITION SizeCovert Camera Setting screen appears Covert Camera SettingAlarm Display Other convenient functionsCommunications by Web Browser AuthenticationCommunications by Web Browser Personal computer product requirementsCommunications by Web Browser WelcomeLive monitor Stop PlaybackTime Search Alarm SearchUser maintenance Select the date and time and click SearchCovert Camera Setting Log outChange log in user Logged in user is changed and the Welcome screen appears HDD continuous recording time for 250GB drive Recording time tableContinuous recording time table Without Audio recordingRecording time table Compact Flash Card continuous recording time for 64MBTroubleshooting Description of problem Please consult the followingTroubleshooting Detection Mask Setting ?Main Image Modified Glossary GlossaryGND SpecificationsConnectors Call OUT/CALL OUT GND
Related manuals
Manual 90 pages 544 b