JVC HM-DR10000EU Basic Connection, Check Contents, Situate Recorder, Mains, Back of TV

4EN

INSTALLINGYOURNEWRECORDER

Basic Connection

Aerial terminal

Back of TV

21-pin SCART

connectorTV Aerial Cable

RF Cable

(provided)

21-pin SCART Cable (provided)

Mains outlet

AV1 OUT switch

Mains power inlet AV1 IN/OUT Rear view

It's essential that your video recorder be properly connected. Follow these steps carefully. THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.

1		CHECK CONTENTS
	Make sure the package contains all of the accessories
		listed in "Specifications" (☞ pg. 82).
2		SITUATE RECORDER
	Place the recorder on a stable, horizontal surface.
		CONNECT RECORDER TO
3		TV
		a– Disconnect the TV aerial cable from the TV.
	b– Connect the TV aerial cable to the ANT. IN jack on
		the rear panel of the recorder.
	c– Connect the provided RF cable between the ANT.
		OUT jack on the rear panel of the recorder and the
		TV’s aerial terminal.
	d– Connect the provided SCART cable between the
		AV1 IN/OUT socket on the rear panel of the
		recorder and the TV’s 21-pin SCART connector.
	e– Set the AV1 OUT switch to the appropriate position.
		See "AV1 INPUT/OUTPUT SIGNAL SELECTION FOR
		AV CONNECTION" below.
		CONNECT RECORDER TO
4		MAINS
	Connect the provided mains power cord between the
		mains power inlet on the rear panel of the recorder and
		a mains outlet.

After you plug the mains power cord into a mains outlet, the Country Set display appears on the TV screen and/or on the

recorder's front display panel when the button on the recorder/remote control is pressed for the first time to power on the recorder; go to page 6 to perform Auto Set Up.

ATTENTION:

Your TV must have a 21-pin AV input connector (SCART) for the connection to the recorder.

AV1 INPUT/OUTPUT SIGNAL SELECTION FOR AV CONNECTION

The AV1 IN/OUT connector accepts and delivers either a composite signal (regular video signal) or a Y/C signal (a signal in which the luminance and chrominance signals are separated). For input signal selection, select "VIDEO" (regular video signal) or "S-VIDEO" (Y/C signal) for "AV1 SELECT" setting (☞ pg. 54). For output signal selection, use AV1 OUT switch of the rear panel.

●If your TV's 21-pin AV input connector (SCART) is compatible only with the regular video signal, set this switch to COMP.

●If your TV's 21-pin AV input connector (SCART) is compatible with the Y/C signal, set this switch to Y/C. You can obtain high- quality S-VHS pictures. (For connection, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.)

NOTES:

●Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to the type of your TV's SCART connector.

●For switching the TV's mode, refer to the instruction manual of your television.

●To obtain high-quality S-VHS pictures, you can also use the S-VIDEO CONNECTION described on page 5.