JVC HM-DR10000EU Preset Download, Press %Þ to select CH - and press OK or #, Link and press OK

8ENINITIALSETTINGS(cont.)

Preset Download

You can use this function only with the TV offering T-V Link, etc.*

*Compatible with TVs offering T-V Link, EasyLink, Megalogic, SMARTLINK, Q-Link, DATA LOGIC or NEXTVIEWLINK via fully- wired 21-pin SCART cable. The degree of compatibility and available functions may differ by system.

When you connect the recorder and your TV via fully-wired

21-pin SCART cable (☞ pg. 4), you can set the recorder's tuner channels by downloading preset data from your TV instead of using the Auto Set Up function (☞ pg. 6). After downloading is completed, the recorder sets the clock and Guide Program number automatically. For details, refer to the instruction manual for your TV.

Perform steps 1 to 3 of "Auto Set Up" on page 6 and 7 before continuing.

PERFORM PRESET DOWNLOAD

1	Press OK.
	If you are referring to the front display panel
	Press %Þ to select "CH – –" and press OK or #.
	If you are referring to the on-screen display
	Press %Þ to move the
	highlight bar (pointer) to	AUTO SET
	"T-V LINK" and press OK
	or #.
		T-V LINK

1

2

1

– –:– –

1 2 3

4 5 6

7 8 9

0

3

4

4

MENU

3OK

[5°] =

[MENU] : EXIT

Preset position on the display panel increases from "CH1"; do NOT press any button on the recorder or remote control until the display panel shows clock time, "(CH) 1" or "– –:– –" as illustrated on page 9.

● If you are using the on-

2

screen display, the T-V

LINK screen will appear.	T-V LINK
Then the GUIDE PROG	PLEASE WAIT
SET screen will appear
during Guide Program
number set.
● If you press any button
on the recorder or	[MENU] : EXIT
remote control while
downloading is in
progress, it will be
interrupted.	GUIDE PROG SET
	PLEASE WAIT

NOTES:

[MENU] : EXIT

●In the area where no TV station transmits a PDC signal, the recorder can perform neither auto clock set nor auto Guide Program number set.

●If there is a power cut, or if you press or MENU while downloading or set up is in progress, it will be interrupted; be sure to turn off the recorder power once and try again from the beginning.

●Auto clock may not function properly depending on the reception condition.

●When you perform T-V LINK function, be sure to use fully- wired 21-pin SCART cable.

●On this recorder, the characters available for station’s name

(ID) are A–Z, 0–9, –, *, + and (space). Some downloaded station’s name may differ from those of your TV (☞ pg. 66).