JVC HM-DR10000EU specifications Error Code

74EN

TROUBLESHOOTING(cont.)

Error Code

Some error codes may appear on the TV screen when operating the recorder. Refer to the chart below for the solution.

ERROR CODE	SYMPTOM	SOLUTION
102	● When a signal in which only the analog	It is not possible to record a digitally copy protected
	information is copy protected has been input for	signal.
	the dubbing in D-VHS mode.
103	● When a signal which is digitally copy protected	It is not possible to record a digitally copy protected
	has been input for dubbing in D-VHS mode.	signal.
104	● When a signal which cannot be digitally converted	Sometimes a programme can be recorded but not
	by the recorder has been recorded.	played back because the signal system is not
		supported by the recorder. Switch to analog input
		such as "L-1" to record.
105	● When making an S-VHS/VHS recording of a signal	The recorder’s DV IN connector (i.Link) is especially
	from DV IN connector (i.Link).	for D-VHS recording. The digital signal is not
		converted to analog and then recorded. Switch to
		analog input such as "L-1" to record.
200	● When a signal which cannot be digitally converted	Playback is impossible because a signal system not
	by the recorder has been input and played back.	supported by the recorder has been input.
201	● When normal playback is impossible such as with	The recorder is making adjustments in order to
	a mosaic (block-shaped noise).	display normal picture. Please wait.
205	● When an attempt is made to play back a D-VHS	This tape cannot be played back by this recorder.
	recorded tape that has been found to be invalid.
300	● When a signal which cannot be digitally converted	Nothing can be seen or heard because the signal
	by the recorder has been input.	system is not supported by the recorder.