Kramer Electronics RC-SV manual Device Menu Features, Connect Dialog Box

Page 34

The Kramer RC Configuration Menus

6.4 The Device Menu

Figure 43 illustrates the Device menu and Table 8 defines it:

Table 8: Device Menu Features

Menu Command	Function
Connect¼	Click to connect to a device via
	an IP number or serial port.
Disconnect	Click to disconnect the device
Properties1	Click to show the device
	properties dialog box.
Write Configuration1	Writes the configuration to the
	device.
Load Firmware	Load file for firmware upgrade.
Set As Slave	Enabled when the RC is
	connected as a stand alone unit.
	Lets you set the device as a
	slave. The RC controller will
	automatically disconnect.

Figure 43: The Device Menu

6.4.1The Connect Command

To connect a device, do the following:

1.Open the Device menu and click Connect. The Connect window appears (see Figure 44).

2.Select the Connection method and type the IP number of the desired device (or port).

Table 9: Connect Dialog Box

				Feature	Function
				Connection	Check Ethernet to select
				Method Area	connection to the device via the
					Ethernet.
					Check Usb to select connection to
					the device via a USB connector.
				Ethernet Area	IP: Type the IP number of the
					device you want to connect to.
					Port: shows the port number.
					Factory Default Address Button:
					Press to reset the IP number to its
					default value.
				USB Area	Port: select the communication USB
	Figure 44: Device Selection Dialog Box				port.
	Figure 44: Device Selection Dialog Box				Refresh ports: click to check if there
					are ports ready to connect on the
					Kramer device.

	1 Active only when a device is connected

30				KRAMER: SIMPLE CREATIVE TECHNOLOGY

Image 34

Contents RC-SV Configuration Guide Contents Figures Tables Introduction OverviewMicrosoft Windows XP is the recommended operating system3 Initial Planning Media Room Components ListRC Configuration Software Installing the SoftwareInstall the Kramer RC Configuration 2 application Downloading and Installing the Drivers Change Working Directory WindowOpen the Kramer RC Configuration 2 program Define the Driver Manager window Driver Manager Window Driver Manager Window Features Feature FunctionSerial Command type area appears, as illustrated in Figure Creating an IR Command IR Command Area Window Port MappingSony DVD Player in the RC Command Area Kramer RC Configuration Main Window Port Manager Window FeaturesKramer RC Configuration Window Features Device AreaShows the Event Macros Tab Shows the Toggle button behavior Switcher Port RC Command Area Ignore Button Port RC Command Area Creating a MacroCreating a New Command Setting the Delay Time and Button Lighting Labeling the ButtonsCreating a Driver Command Switch to COMP1 CommandRelay Command Turn Lights on Power Amplifier Command An LCD Keypad Command Ignore Button Command File Menu Features Kramer RC Configuration MenusFile Menu Configuration Menu Features Configuration MenuEdit Menu Features Edit MenuDevice Menu Device Menu FeaturesConnect Dialog Box Help Menu Features Help MenuLoad Firmware Upgrade Window SV-551 Load FirmwareLoad Firmware Upgrade Window RC-6x Connecting a Room Controller as a Stand Alone Device Master Transforming to the Stand Alone ConfigurationPort Manager in the Stand Alone Mode Device Properties Window in the Stand Alone ModeConnecting via the Ethernet Local Area Connection Properties WindowWriting a Configuration Internet Protocol TCP/IP Properties WindowLoading a Configuration