Kramer Electronics RC-SV Writing a Configuration, Internet Protocol TCP/IP Properties Window

Writing a Configuration

6.Select Use the following IP Address, and fill in the details as shown in Figure 54.

7.Click OK.

Figure 54: Internet Protocol (TCP/IP) Properties Window

8.2Connecting the ETHERNET Port via a Network Hub (Straight- Through Cable)

You can connect the Ethernet port of the RC device to the Ethernet port on a network hub or network router, via a straight-through cable with RJ-45 connectors.

9 Writing a Configuration

Once your configuration is ready, you can write it to the device, via the ª Write Configurationº button.

Note that if the room controller is defined as a:

￿Master (stand alone), the configuration is written directly to the device

￿Slave device (the room controller is connected to the SV-551), the configuration is written to the SV-551

In case you have written the configuration to a stand alone device and it is now connected as a slave to the SV-551, you have to write the configuration once again after defining the device as a slave.

37