Calling up the menu display, selecting an item

ON-SCREEN MENU CONTROLS

By calling up the menu display on screen, various functions can be selected and set as needed.

Calling up the menu display, selecting an item

1. Press the MENU button to call up the menu display on screen (see 1 below). (Press again to make the display disappear.)

2. Press the ▲ or ▼ button to select an item to be set. “” is indicated for the selected item.

3. Press the or button to change the setting.

4. After selecting another item by pressing the ▲ or ▼ button, repeat step 3. These settings are all kept in memory after power is turned off.

5. Press the MENU button to complete. The menu display disappears.

NOTE

●When the menu display 1 (shown at left below) is on screen, press the ENTER button. The display changes to 2 (shown below center). In this state, you can also select the item or change the setting.

●When the display 2 is on screen, each time the ▼ button is pressed while the ENTER button pressed, the indication moves up or down on screen (the display 3). Press the MENU button with display 2 or 3 on screen, and the display is restored to 1.

●If no operation occurs for about 5 minutes after calling up the menu display on screen, the display disappears automatically.

ASPECT	RAT I O		qMENU r
			:4-3
F I LTER	SELECT :COMB
PEAK I NG		FREQ. :2.6MHZ
PEAK I NG		LEVEL:0dB
AFC			:NORMAL
COLOR	TEMP.		:6500
NTSC	SETUP		:7.5
COMPO. LEVEL			:BETA75
qMEMORY MODE r
RGB / COMPO(SDI)			:RGB
ENTER			:

AFC:NORMAL

ASPECT RATIO (picture aspect ratio switching)

The aspect ratio of the picture can be switched between 4:3 and 16:9. When switching to “16-9” on screen, the height of the picture is slightly reduced (see right).

● 4:3

Setting	Function
4-3	Standard picture aspect ratio (4:3)
16-9	Displays the picture in 16:9 aspect ratio

●16:9

FILTER SELECT (built-in filter selection)

When a composite video signal of the NTSC system (excluding NTSC

4.43) is input to the monitor, either or both of two filters in the monitor can be activated.

Setting	Function
COMB (comb filter)	Reduces colour noise in NTSC video signals for clearer pictures.
BOTH (both filters)	Both comb and trap filters function at the same time.
NOTCH (Trap filter)	Eliminates dot interference that would show up in the vertical
	boundary between two different colours.

NOTE

●The function can be operated and the indication appears only when a composite video signal of the NTSC system (excluding NTSC 4.43) is input to the monitor.