JVC BM-H1900SU To program an ID number use front controls, To assign a monitor use remote control

Page 19

EACH REMOTE CONTROL OF PLURAL MONITORS

To operate or adjust plural units of monitors, by programming and assigning an ID number (00 to 99) for each monitor, a specified monitor can be remote-controlled.

To program an ID number (use front controls):

1. Press the POWER switch to turn the power off.

2. With the ▼ and MENU buttons pressed, press the POWER switch to turn the power on. Keep pressing the ▼ and MENU buttons until 1 appears.

3. Press the ▲ or ▼ button to select ID NUMBER SET. Then press the ENTER button to display 2.

4. Select an ID number.

Press the button to increase. Press the button to decrease.

5. Press the ENTER button to program.

To call up an ID number (use remote unit):

1. Press the DISPLAY key to indicate a programmed ID number at top right of the screen.

●Red-indicated ID number:

indicates the monitor can be remote-controlled.

●Green-indicated ID number:

indicates the monitor cannot be remote-controlled.

2.Press the DISPLAY key to make the number disappear.

qIN I T IALIZE MENU r

I D NUMBER SET

qSET - UP MENU rRESET

ENTER

1

qID NUMBER SET r

00

2

NOTE

●ID number 00 is always indicated in red.

To assign a monitor (use remote control):

1. Press the DISPLAY key to display the monitor’s programmed ID number.

2. Press the numeric keys to enter the monitor’s ID number. The entered ID number appears and blinks on screen center.

3. Press the ID SET key to complete.

The programmed ID number in the top right of the screen turns red to indicate the monitor was assigned. Other monitors’ ID numbers are indicated in green.

4. After adjusting the monitor, repeat steps 2 to 4 to adjust each monitor if necessary.

5. Press the DISPLAY key to clear on-screen ID numbers.

Programmed 15 ID number

15 Assigned ID number

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents BM-H1310SU Information Safety PrecautionsFeatures ContentsControls and Features Front Terminals and Features Rear Connection Example RGB/COMPOSDI terminal settingExternal/internal synchronization To demagnetize the picture tube Basic OperationBright picture brightness Picture AdjustmentsPhase picture hue Contrast picture contrastPush each switch to on or OFF for video signal control Video Signal ControlsCalling up the menu display, selecting an item Aspect Ratio picture aspect ratio switchingFilter Select built-in filter selection COMPO. Level chrominance level setting AFC switching of time constant for the AFCColor TEMP. color temperature switching Ntsc Setup Ntsc set-up levelRevision of memory mode Variable setting range Memory ModeTo call up SET-UP Menu and select a function SET-UP for Monitor InstallationTALLY/REMOTE terminal functions Remote Select TALLY/REMOTE-terminal settingsInput setting indications and selected inputs CNTL-1/CNTL-2 setting indications and set positionsStatus Display setting the status display to on/off SET-UP for Monitor InstallationTo initialize Menu settings only Picture Setting InitializationTo initialize both MENU/SET-UP Menu settings On-screen menu remote operation Remote ControlsPicture adjustments Sound adjustmentsTo program an ID number use front controls To assign a monitor use remote controlTo call up an ID number use remote unit Before Calling for Service ¥ + Menu Menu Display ChartRGB / Compo SDI SpecificationsDimensions BM-H1900SU / BM-H1310SU Color Video Monitor
Top Page Image Contents