JVC BM-H1900SU Video Signal Controls, Push each switch to on or OFF for video signal control

Page 9

VIDEO SIGNAL CONTROLS

Push each switch to ON or OFF for video signal control.

UNDER SCAN

Push the UNDER SCAN switch to reduce the dimensions of display area so the whole picture is displayed on screen. Use to check the picture frame.

PULSE CROSS

Push the PULSE CROSS switch to simultaneously display two blank areas crossed horizontally and vertically on screen (“Pulse Cross” display) by delaying the phase of the input signal. Use to check the vertical retrace line period, equalizing pulse period, vertical sync period, horizontal sync pulse, or burst signal.

NOTE

● This function is not effective for analog RGB signal input.

COLOR OFF

Push the COLOR OFF switch to display a black-and-white picture by inputting a luminance signal only. Use to check the noise contained in a luminance signal or white balance.

BLUE CHECK

Push the BLUE CHECK switch to display a monochrome blue picture by eliminating red and green signal components. Use to check or adjust the CHROMA and/or PHASE controls.

NOTE

●This function is not effective for analog RGB signal input.

9

Image 9

Contents BM-H1310SU Information Safety PrecautionsFeatures ContentsControls and Features Front Terminals and Features Rear RGB/COMPOSDI terminal setting Connection ExampleExternal/internal synchronization To demagnetize the picture tube Basic OperationPhase picture hue Picture AdjustmentsContrast picture contrast Bright picture brightnessPush each switch to on or OFF for video signal control Video Signal ControlsAspect Ratio picture aspect ratio switching Calling up the menu display, selecting an itemFilter Select built-in filter selection Color TEMP. color temperature switching AFC switching of time constant for the AFCNtsc Setup Ntsc set-up level COMPO. Level chrominance level settingRevision of memory mode Variable setting range Memory ModeTo call up SET-UP Menu and select a function SET-UP for Monitor InstallationInput setting indications and selected inputs Remote Select TALLY/REMOTE-terminal settingsCNTL-1/CNTL-2 setting indications and set positions TALLY/REMOTE terminal functionsStatus Display setting the status display to on/off SET-UP for Monitor InstallationPicture Setting Initialization To initialize Menu settings onlyTo initialize both MENU/SET-UP Menu settings Picture adjustments Remote ControlsSound adjustments On-screen menu remote operationTo assign a monitor use remote control To program an ID number use front controlsTo call up an ID number use remote unit Before Calling for Service ¥ + Menu Menu Display ChartRGB / Compo SDI SpecificationsDimensions BM-H1900SU / BM-H1310SU Color Video Monitor