Quick Setup
STEP I
Select the speaker configuration setting that you have set for the RCS 2.2x
Operating Mode. This setting is found in the "MODE" menu on the front panel of the
Select:
2.2operating mode - If your system uses two main loudspeakers and two subwoofers.
2.1operating mode - If your system uses two main loudspeakers and one subwoofer.
2.0operating mode - If your system uses only two main loudspeakers.
You will then need to set the Loudspeaker Crossover Frequency or Loudspeaker Lower Cutoff frequency. Your Operating Mode selection will determine what parameters will need to be set. Your subwoofer and main loudspeaker frequency response will determine the settings needed for these parameters. Please refer to your main loudspeaker and /or subwoofer manual for this information.
- If you have selected 2.2 or the 2.1 operating mode you will need to set the:
Loudspeaker crossover frequency (this sets the lowest frequency that will be sent to your loudspeakers.)
Subwoofer lower cutoff frequency (this is the lowest frequency that your subwoofer can reproduce)