Update the RCS-2.2 X Firmware
Your RCS-2.2 X has been pre-programmed with the latest firmware when shipped from our factory and does not need to updated with the program CD that came with your unit. TacT Audio may occasionally release updated versions of the RCS software that will be available on our website “www.tactaudio.com”. This new software may contain updates or enhancements for your RCS-2.2 X. When instructed by a technician or messaged from our website please follow the instruction below to update your RCS-2.2 X firmware.
First un-install the current version of the TacT-2.2X RCS software on your computer.
1 - Turn on your computer.
2 - Open the Windows control panel and select the “Add/Remove Programs” option.
3- Highlight the “TacT-2.2X” option and click on “Change/Remove”.
4- Select “Yes” and the old 2.2X software will be removed.
NOTE:Your target curves and measurements stored under unique names will NOT be removed.
You now need to install the new TacT-2.2X RCS software on your computer.
-Double-click on the “Tact 2.2X vx.x.exe” file that you have downloaded or is found on the root of your CD and follow the installation instructions.
Program the new firmware for the RCS-2.2 X.
1 - Connect the PC to the RCS2.2X using the RS232 cable. Please refer tothe RCS 2.2X RS232 section of the user’s manual or the RS232 Connection document for help.
CAUTION: The RCS-2.2 X should be the only device connected to the RS232 cable during system reprogramming. Please disconnect any TacT digital amplifiers that may be daisy chained to the RCS-2.2 X.
2 - Start the TacT-2.2X RCS software on your computer
3 - Use the “Communication” option in the Tact-2.0 S room correction software to make sure that the RCS-2.2 X and your computer are communicating. Please refer
to the RCS 2.2X RS232 section of the user’s manual or the RS232 Connection document for help.
4 - Turn the RCS-2.2 X OFF from the rear panel mains switch.
