Teledyne THCD-100 instruction manual Appendix B, Setting Default Value Additional Information

Page 26

7.2.Appendix B

Table 2 – Factory Defaults

Setting	Default Value	Additional Information

Repeat Rate (for output readings)	0	Repeat off

Serial Communications Baud	57600

Serial Communications Protocol	1	RS232

Communicationss Address	a

Input Channel Units String	“”	No units strings set

Input Channel Range	10.00

Input Channel Full Scale	10.000

Input Channel Display Precision	2	2 decimal places

Input Channel User Rezero	0.0	No rezero set

Setpoint Value	0.0

Setpoint Slave Value	0.0%

Setpoint Source	0	Internal source

Setpoint Mode	0	AUTO mode

Date of Last Factory Calibration	010101

Adaptive Filter Band	0.2%

Adaptive Filter Buffer Size	2	2 seconds

Relay Trip Point (for both relays, if factory fitted)	10.0

Relay Hysteresis (for both relays, if factory fitted)	2.0%

165-072011 THCD-100 Power Supply

Page 26 of 28

Image 26

Contents Teledyne Hastings Manual Print History Table of Contents General Information FeaturesSpecifications Pin Number Designation InstallationTransducer socket Pinout 15 Pin D Type Serial Socket Pinout 9 Pin D Type Interface Socket Pin out Miniature 15 Pin D TypeInterface Pin Number Designation 1Power Connection Socket Panel MountingAnalog Inputs FeaturesIntroduction Analog OutputsAdaptive Filtering Setpoint ModeUser Re-zero Setpoint SourceFilter Size Menu Screens Common Switch FunctionsEdit Mode Editable ScreensMain Screen not changing setpoint Switch FunctionsFront Panel Screens Main Screen changing setpointSetpoint Screen Switch FunctionsMain Menu Screen Input Screen Filtering ScreenComms Menu Screen Serial ScreenFactory Defaults Confirmation Screen Relay ScreenCommand/Query Format Serial CommunicationOutput Current Readings Repeatedly ‘rp’ Main CommandsOutput Current Readings ‘r’ Setpoint Source ‘sps’ Setpoint Mode ‘spm’Setpoint Value ‘spv’ Setpoint Initial Value ‘siv’Serial Baud Rate ‘bra’ Serial CommandsSetpoint Initial Mode ‘sim’ Serial Communication Protocol ‘pro’Channel Setup Commands Filtering CommandsRelay Trip Point ‘rlt’ Relay Control CommandsFilter Size ‘fls’ Relay Hysteresis ‘rlh’User Input Re-zero ‘irz’ Other CommandsRetrieve All Settings ‘ras’ Date of Last Factory Calibration ‘dlc?’Cleaning Service & CalibrationService End of LifeAppendices Appendix aSetting Default Value Additional Information Appendix BDescription Type and size Settings in ‘ras’ command stringAppendix C Non-Warranty Repair Policy WarrantyWarranty Repair Policy