Teledyne THCD-100 instruction manual Manual Print History

Page 2

Manual Print History

The print history shown below lists the printing dates of all revisions and addenda created for this manual. The revision level increases alphabetically as the manual undergoes subsequent updates. Addenda, which are released between revisions, contain important change information that the user should incorporate immediately into the manual. Addenda are numbered sequentially. When a new revision is created, all addenda associated with the previous revision of the manual are incorporated into the new revision of the manual. Each new revision includes a revised copy of this print history page.

Revision A (165-072011)

July 2011

Visit www.teledyne-hi.com for WEEE disposal guidance.

Please read this manual carefully before using the instrument.

Use of this equipment in a manner not specified in this manual may impair the user’s protection.

Hastings Instruments reserves the right to change or modify the design of its equipment without

any obligation to provide notification of change or intent to change.

165-072011 THCD-100 Power Supply

Page 2 of 28

Image 2

Contents Teledyne Hastings Manual Print History Table of Contents General Information FeaturesSpecifications Pin Number Designation InstallationTransducer socket Pinout 15 Pin D Type Serial Socket Pinout 9 Pin D Type Interface Socket Pin out Miniature 15 Pin D TypeInterface Pin Number Designation 1Power Connection Socket Panel MountingAnalog Inputs FeaturesIntroduction Analog OutputsAdaptive Filtering Setpoint ModeUser Re-zero Setpoint SourceFilter Size Menu Screens Common Switch FunctionsEdit Mode Editable ScreensMain Screen not changing setpoint Switch FunctionsFront Panel Screens Main Screen changing setpointSetpoint Screen Switch FunctionsMain Menu Screen Input Screen Filtering ScreenComms Menu Screen Serial ScreenFactory Defaults Confirmation Screen Relay ScreenCommand/Query Format Serial CommunicationOutput Current Readings Repeatedly ‘rp’ Main CommandsOutput Current Readings ‘r’ Setpoint Source ‘sps’ Setpoint Mode ‘spm’Setpoint Value ‘spv’ Setpoint Initial Value ‘siv’Serial Baud Rate ‘bra’ Serial CommandsSetpoint Initial Mode ‘sim’ Serial Communication Protocol ‘pro’Channel Setup Commands Filtering CommandsRelay Trip Point ‘rlt’ Relay Control CommandsFilter Size ‘fls’ Relay Hysteresis ‘rlh’User Input Re-zero ‘irz’ Other CommandsRetrieve All Settings ‘ras’ Date of Last Factory Calibration ‘dlc?’Cleaning Service & CalibrationService End of LifeAppendices Appendix aSetting Default Value Additional Information Appendix BDescription Type and size Settings in ‘ras’ command stringAppendix C Non-Warranty Repair Policy WarrantyWarranty Repair Policy