Runco VX-33I operation manual VX-33i Rear Panel

2.2

VX-33i Rear Panel

HD3 (VGA / Y-Pb-Pr)

Pr)-Pb-Y / (VGA HD3

HD2 (BNC)

(BNC) HD2

.cover lamp the off pull to screw the Remove

Remove the screw to pull off the lamp cover.

Figure 2-2shows the VX-33i rear panel.

16	15	14	13
	WIRED REMOTE
	REMOTE WIRED
	Service port.
	Not for user
	access
	HD1 (RCA)
	(RCA) HD1
			SERVICE PORT
			AUTHORIZED
			PERSONNEL ONLY
			L

L

2	4	6	8	10	12
1	3	5	7	9	11

Figure 2-2. VX-33i Rear Panel

1.LAMP COVER

Remove this cover to access the lamp compartment.

2.VACUUM FLUORESCENT DISPLAY (VFD)

Can be used instead of the OSD. Displays currently-selected menu or – if no menu is selected – the current source, input resolution and aspect ratio.

If an error condition occurs, a message	Please check issue(s)
appears here indicating the cause:
	Communication Error

3.RUN LED

–Lights blue to indicate that the projector is functioning normally.

–Flashes blue (one second on/one second off) to indicate an error condition.

–Flashes blue (one half-second on/one half-second off) for approximately 90 seconds after the system is turned off.

4.ISSUE LED

Lights red to indicate an error condition.

6 Runco VX-33i Installation/Operation Manual