Runco VX-33I Installing and Adjusting the CineWide Anamorphic Lens, Assembly to Lens Motor

3.11 Installing and Adjusting the CineWide Anamorphic Lens

If you are installing a CineWide-equipped projector, proceed as follows to install and adjust the anamorphic lens.

It is extremely important that the primary lens is properly

Note adjusted before you install the anamorphic lens. Ensure that the image from the primary lens is perfectly centered on the screen.

Attach Lens Mounting ➤	The VX-33i Anamorphic lens mount kit consists of everything shown in Figure 3-18.Some
Assembly to Lens Motor	components shipped with your projector may differ slightly from what is shown in these
Carriage Plate (CineWide	instructions. If any items are missing or damaged, please contact your Runco dealer or
with AutoScope) or Base	Runco Customer Service at (800) 23RUNCO.
Plate (fixed CineWide)

1 Lens Adapter Ring and

Mounting Screws (3x)

10 Anamorphic Lens

Set Screw

9 Pitch Adjustment

T-Nut (2x)

2 Pitch Adjustment Yoke for Lens

3 Height/Y Adjustment

T-Screw and Washer

(2x)

4 Pitch Adjustment

T-Screw and

Washer (2x)

5 Anamorphic Lens

Holder

8 Yaw/X Adjustment

Lever (2x)

6 1/4-20 Hex Bolt (2x)

and Washer (2x)

7 AutoScope Carriage Plate or Fixed CineWide Base Plate

Figure 3-18. VX-33i Anamorphic Lens Mounting Assembly - Exploded View

1.Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the Anamorphic Lens Holder (item #5).

38 Runco VX-33i Installation/Operation Manual