Runco CR-32HD, CR-40HD manual Connections, Connecting to the Video, Or INPUT2

Page 13

Connections

To view television channels, a signal must be input from either an outdoor antenna or a cable television system.

1.Connect the antenna or input cable to the 75 Ω coaxial input on the rear of the display.

2.If you are using an indoor antenna, you may need to turn it when tuning your television until you receive a clear picture.

Rear of the TV

ANT

or

Cable Television

Network

Connecting an Antenna or Cable (Not applicable on the CR-40HD)

Rear of the display

INPUT1

Right side of the display

Input2

S-Video

R

Audio

L

Video

(A) For Video (RCA) Input	Connecting to the Video
	Connecting to the Video
	or S-Video Input (INPUT1
	or INPUT2)

(B) For S-Video Input

(A) For Video Input

1.Connect the RCA cable to the input jacks (video+ audio L/R of Input1 or Input2) on the display and output jacks on the external equipment such as a VCR, camcorder and some video game devices.

(B) For S-Video Input

1.Connect the S-Video/RCA (audio L/R of Input1 or Input2) cable to the input jacks on the display and output jacks on the external equipment such as a VCR, camcorder and some video game devices.

2.If the external equipment has mono audio output, connect it only to left jack of the Audio Input/Output.

13

Image 13

Contents CR-32HD / CR-40HD Table of Contents RS-232 Configurations ISF Calibration ServiceSignals Supported Pin Configuration PC/DVIWhat is Covered Under the Terms of this Limited Warranty One Year Limited WarrantyRIGHTS, Limits and Exclusions Runco INTERNATIONAL, INC Introduction DOC compliance Notice PrecautionsCR-32HD and CR-40HD Power Indicator StatusFront View Input2 CR-32HD Rear View Input Panel13 14 CR-40HD Rear View Input Panel100 Remote ControlConnections Connecting to the VideoOr INPUT2 Connecting to a DVD or DTV Set-Top Box Input RCA or DVI Using the Monitor OUT featureTo use the display as a PC Monitor Connecting to a PCSetting the PC Properties Connecting Headphones Basic Operations Connecting the Power Cord and Switching Display On / OffStandard 43 mode Anamorphic modeLetterbox mode Virtualwide modePress the Menu button on the remote control Selecting Picture AdjustSave Settings Restore SettingsSelecting Channel Selecting AudioSelecting Timer PC Mode Adjust SetupOSD Language CC1 CC2 CC3 CC4 Text1 Text2 Text3 Text4 Parental Control CaptionMonitor Out Input SelectionOverscan Picture Adjust ISF Calibration ServiceISF Calibration White BalanceCommand Ack Blue Enable DNR Digital Noise ReductionFactory Reset GammaDisplaying the Picture in Picture PIP Picture in Picture PIPSmall Twin Off Changing the PIP Position Selecting the Image Mode in the PIPChanging the PIP Size Selecting the Image Size in the PIPSwapping the Main & Sub-Sound Swapping the Main & Sub-PictureChanging the PIP Aspect Ratio Wide 169 modeListening to Stereo Sound / SAP Stereo Sound / SAPOption BroadcastingRS-232C Configurations RS-232 ConfigurationsPin 1 Ground Serial Protocol ‘\n’Timer OFF Mode Freq Hz Freq KHz Signals SupportedPC Input Connector D-Sub 15Pin Pin Configuration PC/DVIDVI-D Connector For Display Panel TroubleshootingFor Monitor CR-32HD SpecificationsCR-40HD DimensionsRUMA-011095