Runco CR-40HD, CR-32HD manual Input Selection, Monitor Out, Overscan

Page 24

Setup

Input Selection

Setup

OSD Language

PC Mode Adjust

Caption

Parental Control

Letterbox Mode

Input Selection

Monitor Out

Overscan

Input1 Video

Input2 S-Video

Input3 Video

Input4 Component

1.Press the ▲▼ buttons to select Input Selection and then press the ENTER or ► button.

2.Press the ▲▼ buttons to highlight Input1, Input2, Input3 or Input4 and press the Enter button.

3.Press the ► button to toggle the selection.

Input1 and Input2 can be assigned for S-Video or Video (Composite) Input3 and Input4 can be assigned for Component or Video (Composite)

Monitor Out

Setup

OSD Language

PC Mode Adjust

Caption

Parental Control

Letterbox Mode

Input Selection

Monitor Out

Overscan

>Main

PIP

1.Press the ▲▼ buttons to select Monitor Out and then press the ENTER or ► button.

2.Press the ▲▼ buttons to highlight Main or PIP and then press the Enter button. An arrow will indicate the selected window.

Overscan

Setup

OSD Language

PC Mode Adjust

Caption

Parental Control

Letterbox Mode

Input Selection

Monitor Out

Overscan

H.Overscan 0

H.Shift4

V.Overscan 0

V.Shift0

1.Press the ▲▼ buttons to select Overscan and then press the ENTER or ► button.

2.Press the ▲▼ buttons to highlight H.Overscan, H.Shift, V.Overscan or V.Shift and then press the Enter button.

24

Image 24
Contents CR-32HD / CR-40HD Table of Contents ISF Calibration Service RS-232 ConfigurationsSignals Supported Pin Configuration PC/DVIOne Year Limited Warranty What is Covered Under the Terms of this Limited WarrantyRIGHTS, Limits and Exclusions Runco INTERNATIONAL, INC Introduction Precautions DOC compliance NoticePower Indicator Status CR-32HD and CR-40HDFront View CR-32HD Rear View Input Panel Input2CR-40HD Rear View Input Panel 13 14Remote Control 100Connecting to the Video ConnectionsOr INPUT2 Using the Monitor OUT feature Connecting to a DVD or DTV Set-Top Box Input RCA or DVIConnecting to a PC To use the display as a PC MonitorSetting the PC Properties Connecting Headphones Connecting the Power Cord and Switching Display On / Off Basic OperationsAnamorphic mode Standard 43 modeLetterbox mode Virtualwide modeSelecting Picture Adjust Press the Menu button on the remote controlSave Settings Restore SettingsSelecting Audio Selecting ChannelSelecting Timer Setup PC Mode AdjustOSD Language Caption CC1 CC2 CC3 CC4 Text1 Text2 Text3 Text4 Parental ControlInput Selection Monitor OutOverscan ISF Calibration Service Picture AdjustISF Calibration White BalanceBlue Enable DNR Digital Noise Reduction Command AckFactory Reset GammaPicture in Picture PIP Displaying the Picture in Picture PIPSmall Twin Off Selecting the Image Mode in the PIP Changing the PIP PositionChanging the PIP Size Selecting the Image Size in the PIPSwapping the Main & Sub-Picture Swapping the Main & Sub-SoundWide 169 mode Changing the PIP Aspect RatioStereo Sound / SAP Listening to Stereo Sound / SAPOption BroadcastingRS-232 Configurations RS-232C ConfigurationsPin 1 Ground ‘\n’ Serial ProtocolTimer OFF Signals Supported Mode Freq Hz Freq KHzPin Configuration PC/DVI PC Input Connector D-Sub 15PinDVI-D Connector Troubleshooting For Display PanelFor Monitor Specifications CR-32HDDimensions CR-40HDRUMA-011095