Runco manual CR-32HD and CR-40HD, Front View, Power Indicator Status

Page 9

	Control Panels
	CR-32HD and CR-40HD
	Front View
8	8

Bottom Side

TV/AV

MENU

-

VOL

+

CH

1	2	3		4	5	6	7
1 TV/AV Button (Input Source Selection)				Power Indicator Status
2 MENU Selection Button
2 MENU Selection Button				Indicator		Status
3 Volume Adjustment Buttons				Indicator		Status

				Red		Stand-by
4 Channel Selection Buttons				Red		Stand-by
4 Channel Selection Buttons				Green		Power on
5 Remote Control Sensor				Green blinking	Remote control
5 Remote Control Sensor
6 Power Button
7 Power Indicator

8Speakers

9

Image 9

Contents CR-32HD / CR-40HD Table of Contents RS-232 Configurations ISF Calibration ServiceSignals Supported Pin Configuration PC/DVIWhat is Covered Under the Terms of this Limited Warranty One Year Limited WarrantyRIGHTS, Limits and Exclusions Runco INTERNATIONAL, INC Introduction DOC compliance Notice PrecautionsPower Indicator Status CR-32HD and CR-40HDFront View Input2 CR-32HD Rear View Input Panel13 14 CR-40HD Rear View Input Panel100 Remote ControlConnecting to the Video ConnectionsOr INPUT2 Connecting to a DVD or DTV Set-Top Box Input RCA or DVI Using the Monitor OUT featureTo use the display as a PC Monitor Connecting to a PCSetting the PC Properties Connecting Headphones Basic Operations Connecting the Power Cord and Switching Display On / OffStandard 43 mode Anamorphic modeLetterbox mode Virtualwide modePress the Menu button on the remote control Selecting Picture AdjustSave Settings Restore SettingsSelecting Channel Selecting AudioSelecting Timer Setup PC Mode AdjustOSD Language CC1 CC2 CC3 CC4 Text1 Text2 Text3 Text4 Parental Control CaptionInput Selection Monitor OutOverscan Picture Adjust ISF Calibration ServiceISF Calibration White BalanceCommand Ack Blue Enable DNR Digital Noise ReductionFactory Reset GammaPicture in Picture PIP Displaying the Picture in Picture PIPSmall Twin Off Changing the PIP Position Selecting the Image Mode in the PIPChanging the PIP Size Selecting the Image Size in the PIPSwapping the Main & Sub-Sound Swapping the Main & Sub-PictureChanging the PIP Aspect Ratio Wide 169 modeListening to Stereo Sound / SAP Stereo Sound / SAPOption BroadcastingRS-232 Configurations RS-232C ConfigurationsPin 1 Ground Serial Protocol ‘\n’Timer OFF Mode Freq Hz Freq KHz Signals SupportedPin Configuration PC/DVI PC Input Connector D-Sub 15PinDVI-D Connector For Display Panel TroubleshootingFor Monitor CR-32HD SpecificationsCR-40HD DimensionsRUMA-011095