Runco CR-40HD Setting the PC Properties Connecting Headphones, Right side of the display Input2

Page 16

Connections

Setting the PC Properties

Connecting Headphones

1.First, click on Settings on the Windows Start menu and click on “Control Panel”.

2.Double click on the Display icon.

3.Click on the Settings tab on the display dialog-box.

4.Adjust the resolution to 1024x768 pixels.

5.Click the Advanced button and click the Monitor tab on the dialog-box. Set the vertical-frequency to 60Hz and then click the OK button.

Note:

–Maximum resolution depends on the Video Card.

–Maximum supported resolution is 1024 x 768 @ 75Hz. You can get the best picture at 1024 x 768 @ 60Hz.

–There are 16,770,000 supported colors.

Right side of the display

Input2

S-Video

R

Audio

L

Video

You can connect a set of headphones to your display if you wish to watch a program without disturbing other people.

1. Plug a set of headphones into the 3.5mm mini-jack socket on the right side of your display. Sound will then be routed through the headphones.

Note: Headphones are not included.

16

Image 16

Contents CR-32HD / CR-40HD Table of Contents ISF Calibration Service RS-232 ConfigurationsSignals Supported Pin Configuration PC/DVIOne Year Limited Warranty What is Covered Under the Terms of this Limited WarrantyRIGHTS, Limits and Exclusions Runco INTERNATIONAL, INC Introduction Precautions DOC compliance NoticeCR-32HD and CR-40HD Power Indicator StatusFront View CR-32HD Rear View Input Panel Input2CR-40HD Rear View Input Panel 13 14Remote Control 100Connections Connecting to the VideoOr INPUT2 Using the Monitor OUT feature Connecting to a DVD or DTV Set-Top Box Input RCA or DVIConnecting to a PC To use the display as a PC MonitorSetting the PC Properties Connecting Headphones Connecting the Power Cord and Switching Display On / Off Basic OperationsAnamorphic mode Standard 43 modeLetterbox mode Virtualwide modeSelecting Picture Adjust Press the Menu button on the remote controlSave Settings Restore SettingsSelecting Audio Selecting ChannelSelecting Timer PC Mode Adjust SetupOSD Language Caption CC1 CC2 CC3 CC4 Text1 Text2 Text3 Text4 Parental ControlMonitor Out Input SelectionOverscan ISF Calibration Service Picture AdjustISF Calibration White BalanceBlue Enable DNR Digital Noise Reduction Command AckFactory Reset GammaDisplaying the Picture in Picture PIP Picture in Picture PIPSmall Twin Off Selecting the Image Mode in the PIP Changing the PIP PositionChanging the PIP Size Selecting the Image Size in the PIPSwapping the Main & Sub-Picture Swapping the Main & Sub-SoundWide 169 mode Changing the PIP Aspect RatioStereo Sound / SAP Listening to Stereo Sound / SAPOption BroadcastingRS-232C Configurations RS-232 ConfigurationsPin 1 Ground ‘\n’ Serial ProtocolTimer OFF Signals Supported Mode Freq Hz Freq KHzPC Input Connector D-Sub 15Pin Pin Configuration PC/DVIDVI-D Connector Troubleshooting For Display PanelFor Monitor Specifications CR-32HDDimensions CR-40HDRUMA-011095