Runco CR-40HD, CR-32HD manual Using the Monitor OUT feature

Page 14

Connections

Using the MONITOR OUT feature

You can choose the Main or PIP screen to record. Refer to page 24 for more information.

Rear of the display

VCR, etc.

MONITOR-OUT

Connecting to a DVD or DTV Set-Top Box INPUT (RCA or DVI)

Your display has a monitor out feature which can be used by a second VCR, or other auxiliary equipment.

To do this, connect your second VCR as follows:

1. Connect a set of audio cables between the AUDIO OUT jacks on the display and the AUDIO IN jacks on the VCR, or auxiliary equipment.

2. Connect a video cable between the VIDEO OUT jack on the display and the VIDEO IN jack on the VCR, or auxiliary equipment.

Rear of the display

INPUT4

INPUT3

1.Connect the video cables to the Y, Pb, Pr input jacks (INPUT3 or INPUT4) on the display and the Y, Pb, Pr output jacks on the DVD or DTV Set-Top Box.

2.Connect the audio cables to the Audio L/R input jacks (INPUT3 or INPUT4) on the display and the Audio output jacks on the DVD or DTV Set-Top Box.

1.Connect the DVI cables to the DVI input jacks (DVI) on the display and the DVI output jacks on the DVD or DTV Set-Top Box.

2.Connect the audio cables to the Audio L/R input jacks on the display and the Audio output jacks on the DVD or DTV Set-Top Box.

14

Image 14
Contents CR-32HD / CR-40HD Table of Contents Signals Supported ISF Calibration ServiceRS-232 Configurations Pin Configuration PC/DVIOne Year Limited Warranty What is Covered Under the Terms of this Limited WarrantyRIGHTS, Limits and Exclusions Runco INTERNATIONAL, INC Introduction Precautions DOC compliance NoticeFront View Power Indicator StatusCR-32HD and CR-40HD CR-32HD Rear View Input Panel Input2CR-40HD Rear View Input Panel 13 14Remote Control 100Or INPUT2 Connecting to the VideoConnections Using the Monitor OUT feature Connecting to a DVD or DTV Set-Top Box Input RCA or DVIConnecting to a PC To use the display as a PC MonitorSetting the PC Properties Connecting Headphones Connecting the Power Cord and Switching Display On / Off Basic OperationsLetterbox mode Anamorphic modeStandard 43 mode Virtualwide modeSave Settings Selecting Picture AdjustPress the Menu button on the remote control Restore SettingsSelecting Audio Selecting ChannelSelecting Timer OSD Language SetupPC Mode Adjust Caption CC1 CC2 CC3 CC4 Text1 Text2 Text3 Text4 Parental ControlOverscan Input SelectionMonitor Out ISF Calibration ISF Calibration ServicePicture Adjust White BalanceFactory Reset Blue Enable DNR Digital Noise ReductionCommand Ack GammaSmall Twin Off Picture in Picture PIPDisplaying the Picture in Picture PIP Changing the PIP Size Selecting the Image Mode in the PIPChanging the PIP Position Selecting the Image Size in the PIPSwapping the Main & Sub-Picture Swapping the Main & Sub-SoundWide 169 mode Changing the PIP Aspect RatioOption Stereo Sound / SAPListening to Stereo Sound / SAP BroadcastingPin 1 Ground RS-232 ConfigurationsRS-232C Configurations ‘\n’ Serial ProtocolTimer OFF Signals Supported Mode Freq Hz Freq KHzDVI-D Connector Pin Configuration PC/DVIPC Input Connector D-Sub 15Pin Troubleshooting For Display PanelFor Monitor Specifications CR-32HDDimensions CR-40HDRUMA-011095