Runco CR-32HD, CR-40HD manual Swapping the Main & Sub-Picture, Swapping the Main & Sub-Sound

Page 29

Picture in Picture (PIP)

1.Press the () button on the remote control.

•The Main image and PIP image will switch with each other whenever you press this button.

MENUEXIT

CHANNEL DOWN

ASPECT SIZE POSITION PIP

P.MODE S.SWAP SWAP TV/AV

S.MODE SURRND MTS/SAP MUTE

Swapping the Main & Sub-Picture

➔

➔

1.Press the () button on the remote control.

•The Main sound and PIP sound will switch with each other whenever you press this button.

MENUEXIT

CHANNEL DOWN

ASPECT SIZE POSITION PIP

P.MODE S.SWAP SWAP TV/AV

Swapping the Main & Sub-Sound

S.MODE SURRND MTS/SAP MUTE

29

Image 29

Contents CR-32HD / CR-40HD Table of Contents RS-232 Configurations ISF Calibration ServiceSignals Supported Pin Configuration PC/DVIWhat is Covered Under the Terms of this Limited Warranty One Year Limited WarrantyRIGHTS, Limits and Exclusions Runco INTERNATIONAL, INC Introduction DOC compliance Notice PrecautionsFront View Power Indicator StatusCR-32HD and CR-40HD Input2 CR-32HD Rear View Input Panel13 14 CR-40HD Rear View Input Panel100 Remote ControlOr INPUT2 Connecting to the VideoConnections Connecting to a DVD or DTV Set-Top Box Input RCA or DVI Using the Monitor OUT featureTo use the display as a PC Monitor Connecting to a PCSetting the PC Properties Connecting Headphones Basic Operations Connecting the Power Cord and Switching Display On / OffStandard 43 mode Anamorphic modeLetterbox mode Virtualwide modePress the Menu button on the remote control Selecting Picture AdjustSave Settings Restore SettingsSelecting Channel Selecting AudioSelecting Timer OSD Language SetupPC Mode Adjust CC1 CC2 CC3 CC4 Text1 Text2 Text3 Text4 Parental Control CaptionOverscan Input SelectionMonitor Out Picture Adjust ISF Calibration ServiceISF Calibration White BalanceCommand Ack Blue Enable DNR Digital Noise ReductionFactory Reset GammaSmall Twin Off Picture in Picture PIPDisplaying the Picture in Picture PIP Changing the PIP Position Selecting the Image Mode in the PIPChanging the PIP Size Selecting the Image Size in the PIPSwapping the Main & Sub-Sound Swapping the Main & Sub-PictureChanging the PIP Aspect Ratio Wide 169 modeListening to Stereo Sound / SAP Stereo Sound / SAPOption BroadcastingPin 1 Ground RS-232 ConfigurationsRS-232C Configurations Serial Protocol ‘\n’Timer OFF Mode Freq Hz Freq KHz Signals SupportedDVI-D Connector Pin Configuration PC/DVIPC Input Connector D-Sub 15Pin For Display Panel TroubleshootingFor Monitor CR-32HD SpecificationsCR-40HD DimensionsRUMA-011095