Runco CR-32HD, CR-40HD Listening to Stereo Sound / SAP, Option, Broadcasting, Stereo Mono

Page 31

Stereo Sound / SAP

Depending on the particular program being broadcast, you can listen to stereo, mono, or a Secondary Audio Program. (SAP audio usually a foreign-language translation. Sometimes SAP has unrelated information like news or weather.)

Listening to Stereo Sound / SAP

1.You can select sound options (Mono, Stereo, SAP, Mono+ SAP) depending on

the broadcast signal by pressing the ( ) button on the remote control.

•Choose Stereo for channels that are broadcasting in stereo.

•Choose Mono for channels that are broadcasting in mono, or if you are having difficulty receiving a stereo signal.

•Choose SAP to listen to the Secondary Audio Program, which is usually a foreign- language translation.

MENUEXIT

CHANNEL DOWN

ASPECT SIZE POSITION PIP

P.MODE S.SWAP SWAP TV/AV

S.MODE SURRND MTS/SAP MUTE

	Option	M	S	SAP	M+SAP
Broadcasting		M	S	SAP	M+SAP
Broadcasting
M		M	M	M	M
S		M	S	M	S
M+SAP		M	M	SAP	M+SAP
S+SAP		M	S	SAP	M+SAP
S : Stereo
M : Mono

SAP : Secondary Audio Program

M + SAP : Mono + SAP

S + SAP : Stereo + SAP

31

Image 31

Contents CR-32HD / CR-40HD Table of Contents Pin Configuration PC/DVI ISF Calibration ServiceRS-232 Configurations Signals SupportedWhat is Covered Under the Terms of this Limited Warranty One Year Limited WarrantyRIGHTS, Limits and Exclusions Runco INTERNATIONAL, INC Introduction DOC compliance Notice PrecautionsCR-32HD and CR-40HD Power Indicator StatusFront View Input2 CR-32HD Rear View Input Panel13 14 CR-40HD Rear View Input Panel100 Remote ControlConnections Connecting to the VideoOr INPUT2 Connecting to a DVD or DTV Set-Top Box Input RCA or DVI Using the Monitor OUT featureTo use the display as a PC Monitor Connecting to a PCSetting the PC Properties Connecting Headphones Basic Operations Connecting the Power Cord and Switching Display On / OffVirtualwide mode Anamorphic modeStandard 43 mode Letterbox modeRestore Settings Selecting Picture AdjustPress the Menu button on the remote control Save SettingsSelecting Channel Selecting AudioSelecting Timer PC Mode Adjust SetupOSD Language CC1 CC2 CC3 CC4 Text1 Text2 Text3 Text4 Parental Control CaptionMonitor Out Input SelectionOverscan White Balance ISF Calibration ServicePicture Adjust ISF CalibrationGamma Blue Enable DNR Digital Noise ReductionCommand Ack Factory ResetDisplaying the Picture in Picture PIP Picture in Picture PIPSmall Twin Off Selecting the Image Size in the PIP Selecting the Image Mode in the PIPChanging the PIP Position Changing the PIP SizeSwapping the Main & Sub-Sound Swapping the Main & Sub-PictureChanging the PIP Aspect Ratio Wide 169 modeBroadcasting Stereo Sound / SAPListening to Stereo Sound / SAP OptionRS-232C Configurations RS-232 ConfigurationsPin 1 Ground Serial Protocol ‘\n’Timer OFF Mode Freq Hz Freq KHz Signals SupportedPC Input Connector D-Sub 15Pin Pin Configuration PC/DVIDVI-D Connector For Display Panel TroubleshootingFor Monitor CR-32HD SpecificationsCR-40HD DimensionsRUMA-011095